Literature DB >> 17973246

Solubility, salivary sorption and degree of conversion of dimethacrylate-based polymeric matrixes.

Luana Gonçalves1, Jaime D N Filho, José G A Guimarães, Laiza T Poskus, Eduardo M Silva.   

Abstract

This study investigated the relationship between the solubility, salivary sorption, and degree of conversion of dimethacrylate-based polymeric matrixes. Six polymeric matrixes produced by mixing bis-GMA, TEGDMA and UDMA dimethacrylate monomers were studied. Photoactivation was induced by camphoroquinone/ethyl N,N-dimethyl-4-aminobenzoate. The specimens were light-cured using an irradiance of 850 mW/cm(2) for 20 s. The solubility and sorption (microg/mm(3)) were measured after immersion in artificial saliva (neutral pH) for 7 days. The degree of conversion (%) was obtained by using a FT-IR spectrometer equipped with an attenuated total reflectance crystal (ATR). The degree of conversion varied from 39.15 +/- 6.30 to 65.57+/- 4.80, and was influenced by the viscosity of the monomers present in the polymeric matrixes. The solubility of polymeric matrixes varied between 13.64 +/- 0.39 and 25.08 +/- 0.83, and was strongly influenced by the degree of conversion (Pearson, r = -0.9587, p < 0.01). No correlation was found between salivary sorption and the degree of conversion (p = 0.3918). Salivary sorption was only dependent on the chemical and physical structures of the monomers presented in the polymeric matrixes. Copyright 2007 Wiley Periodicals, Inc.

Entities:  

Mesh:

Substances:

Year:  2008        PMID: 17973246     DOI: 10.1002/jbm.b.30949

Source DB:  PubMed          Journal:  J Biomed Mater Res B Appl Biomater        ISSN: 1552-4973            Impact factor:   3.368


  15 in total

1.  The diffusion kinetics of a nanofilled and a midifilled resin composite immersed in distilled water, artificial saliva, and lactic acid.

Authors:  Eduardo Moreira da Silva; Luana Gonçalves; José Guilherme Antunes Guimarães; Laiza Tatiana Poskus; Carlos Eduardo Fellows
Journal:  Clin Oral Investig       Date:  2010-03-09       Impact factor: 3.573

2.  Influence of the self-adhering strategy on microhardness, sorption, solubility, color stability, and cytotoxicity compared to bulk-fill and conventional resin composites.

Authors:  Natália Gomes de Oliveira; Luís Felipe Espíndola-Castro; Julliana Carvalho Rocha; Amanda Pinheiro de Barros Albuquerque; Moacyr Jesus Barreto de Melo Rêgo; Gabriela Queiroz de Melo Monteiro; Marianne de Vasconcelos Carvalho
Journal:  Clin Oral Investig       Date:  2022-08-02       Impact factor: 3.606

3.  Influence of extended light exposure curing times on the degree of conversion of resin-based pit and fissure sealant materials.

Authors:  Nazish Fatima
Journal:  Saudi Dent J       Date:  2014-07-10

4.  Long-term degradation of resin-based cements in substances present in the oral environment: influence of activation mode.

Authors:  Eduardo Moreira da Silva; Jaime Dutra Noronha-Filho; Cristiane Mariote Amaral; Laiza Tatiana Poskus; José Guilherme Antunes Guimarães
Journal:  J Appl Oral Sci       Date:  2013       Impact factor: 2.698

5.  A critical analysis of the degree of conversion of resin-based luting cements.

Authors:  Jaime Dutra Noronha Filho; Natasha Lamego Brandão; Laiza Tatiana Poskus; José Guilherme Antunes Guimarães; Eduardo Moreira da Silva
Journal:  J Appl Oral Sci       Date:  2010 Sep-Oct       Impact factor: 2.698

6.  Effects of delayed finishing/polishing on surface roughness, hardness and gloss of tooth-coloured restorative materials.

Authors:  A Ruya Yazici; Duygu Tuncer; Sibel Antonson; Alev Onen; Evren Kilinc
Journal:  Eur J Dent       Date:  2010-01

7.  Fabrication and characterization of low-shrinkage dental composites containing montmorillonite nanoclay.

Authors:  Fernanda Pitta Ritto; Eduardo Moreira da Silva; Alexandre Luiz Souto Borges; Márcio Antônio Paraizo Borges; Hélio Rodrigues Sampaio-Filho
Journal:  Odontology       Date:  2021-06-22       Impact factor: 2.634

8.  The effect of three polishing systems on surface roughness of flowable, microhybrid, and packable resin composites.

Authors:  Ahmed Mohammed Hassan; Sameh Mahmoud Nabih; Hossam Mohammed Mossa; Kusai Baroudi
Journal:  J Int Soc Prev Community Dent       Date:  2015 May-Jun

9.  Bacterial viability and physical properties of antibacterially modified experimental dental resin composites.

Authors:  Stefan Rüttermann; Taina Trellenkamp; Nora Bergmann; Thomas Beikler; Helmut Ritter; Ralf Janda
Journal:  PLoS One       Date:  2013-11-01       Impact factor: 3.240

10.  Relationship between the degree of conversion, solubility and salivary sorption of a hybrid and a nanofilled resin composite.

Authors:  Eduardo Moreira da Silva; Giselle Soares Almeida; Laiza Tatiana Poskus; José Guilherme Antunes Guimarães
Journal:  J Appl Oral Sci       Date:  2008 Mar-Apr       Impact factor: 2.698

View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.