Literature DB >> 17238164

Modulated photoactivation methods--effect on marginal and internal gap formation of restorations using different restorative composites.

Roberta C B Alonso1, Gisele M Correr, Leonardo G Cunha, Carlos A De Moraes Souto Pantoja, Regina M Puppin-Rontani, Mário A C Sinhoreti.   

Abstract

UNLABELLED: This study evaluated the effect of modulated photoactivation methods on gap formation of restorations using different composites.
METHODS: Sixty human third molars were selected, sectioned (two fragments), and ground to expose a flat enamel area. A cavity (5 mm long x 2 mm wide x 2 mm deep--outer margins in enamel and inner margins in dentin) was prepared on the central area of flattened surface. Single bond adhesive system was applied according to manufacturer's instructions. The specimens were assigned into 12 groups (n = 10), according to the restorative composite (Filtek Z250, Herculite XRV, and Heliomolar) and the photoactivation method [continuous light (CL); soft-start (SS); pulse delay (PD); and intermittent light (IL)]. Outer margins were stained using Caries Detector, observed under stereomicroscope, and images were transferred to a computer measurement program. Then, the specimens were sectioned in slices and the internal gaps were assigned using the same method. The length of gaps was expressed as a percentage of total length of the margins. Data (internal adaptation) were submitted to ANOVA and Tukey's test.
RESULTS: All restorations showed perfect seal of the enamel outer margins. Modulated photoactivation methods (SS, PD, and IL) showed a significant reduction on internal gap formation when compared with CL, regardless of the composite. Filtek Z250 showed the best internal adaptation, regardless of the photoactivation method.
CONCLUSION: Modulated photoactivation methods decrease the internal gap formation of composite restorations, and should be encouraged on clinical practice.

Entities:  

Mesh:

Substances:

Year:  2007        PMID: 17238164     DOI: 10.1002/jbm.b.30739

Source DB:  PubMed          Journal:  J Biomed Mater Res B Appl Biomater        ISSN: 1552-4973            Impact factor:   3.368


  4 in total

1.  Influence of the LED curing source and selective enamel etching on dentin bond strength of self-etch adhesives in class I composite restorations.

Authors:  Eduardo José Souza-Junior; Cíntia Tereza Pimenta Araújo; Lúcia Trazzi Prieto; Luís Alexandre Maffei Sartini Paulillo
Journal:  Lasers Med Sci       Date:  2011-11-26       Impact factor: 3.161

2.  The effect of curing light and chemical catalyst on the degree of conversion of two dual cured resin luting cements.

Authors:  Eduardo José Souza-Junior; Lúcia Trazzi Prieto; Giulliana Panfiglio Soares; Carlos Tadeu dos Santos Dias; Flávio Henrique Baggio Aguiar; Luís Alexandre Maffei Sartini Paulillo
Journal:  Lasers Med Sci       Date:  2010-11-23       Impact factor: 3.161

3.  Influence of the curing method on the post-polymerization shrinkage stress of a composite resin.

Authors:  Leonardo Gonçalves Cunha; Roberta Caroline Bruschi Alonso; Eduardo José Carvalho de Souza-Junior; Ana Christina Elias Claro Neves; Lourenço Correr-Sobrinho; Mário Alexandre Coelho Sinhoreti
Journal:  J Appl Oral Sci       Date:  2008 Jul-Aug       Impact factor: 2.698

4.  Effect of photoinitiator concentration on marginal and internal adaptation of experimental composite blends photocured by modulated methods.

Authors:  Roberta Caroline Bruschi Alonso; Eduardo José Carvalho de Souza-Júnior; Diogo Dressano; Giovana Albamonte Spagnolo de Araújo; José Manuel Ces Rodriguez; Vinícius Di Hipólito; Camillo Anauate-Netto; Regina Maria Puppin-Rontani; Mario Alexandre Coelho Sinhoreti
Journal:  Eur J Dent       Date:  2013-09
  4 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.