Effect of preparation conditions on protein secondary structure and biofilm formation of kafirin.

Various extraction and drying conditions for the isolation of kafirin from dry-milled, whole grain sorghum have been investigated, with a view to optimizing extraction of the protein for commercial food coatings and packaging films. The addition of sodium hydroxide to an aqueous ethanol extractant increased the yield and solubility of kafirin. Subsequent heat drying at 40 degrees C was shown to cause the kafirin to aggregate as indicated by an increase in intermolecular beta-sheets. Extraction of the flour using ethanol (70%, w/w) with 0.5% (w/w) sodium metabisulfite and 0.35% (w/w) sodium hydroxide at 70 degrees C followed by freeze-drying of the protein was found to produce a yield of 54% kafirin with good film-forming properties. The kafirin films were assessed for their sensory properties, tensile strength, strain, and water vapor permeability. Fourier transform infrared spectroscopy was used to study the secondary structure of the extracted kafirins. The best films were made with kafirin containing a large proportion of nativelike alpha-helical structures with little intermolecular beta-sheet content as indicated by the Fourier transform infrared reflectance peak intensity ratios associated with these secondary structures. The principal factor affecting the secondary structure of the protein appeared to be the temperature at which the protein was dried. Heat drying resulted in a greater proportion of intermolecular beta-sheets. Any industrial-scale extraction must therefore minimize protein aggregation and maximize native alpha-helical structures to achieve optimal film quality.