INTRODUCTION: Antegrade intramedullary (IM) nailing of humeral shaft fractures is reported to cause shoulder joint impairment. This retrospective study compared shoulder joint symptoms, range of motion (ROM), and isometric strength after antegrade IM nailing and dynamic compression (DC) plating of humeral shaft fractures. MATERIALS AND METHODS: We compared 29 patients with DC plating and 44 with antegrade IM nailing of their humeral shaft fractures. Shoulder pain, L'Insalata and Constant scores, shoulder joint ROM and isometric shoulder strengths were measured after mean follow-up of 6.2 (1-15) years (DC plating) and 5.5 (2-10) years (IM nailing). RESULTS: Patients had nonsignificantly more shoulder pain after IM nailing than after DC plating. Shoulder scores and isometric strength measurements showed no difference between the groups. Flexion was significantly better after DC plating, but none of the other ROM parameters differed between the groups. The shoulder scores and all ROM and strength parameters of the injured side were significantly lower than on the uninjured side in both groups. CONCLUSIONS: Shoulder joint ROM and strength does not recover to normal after humeral shaft fracture. Antegrade IM nailing if performed properly is not responsible for shoulder joint impairment.
INTRODUCTION: Antegrade intramedullary (IM) nailing of humeral shaft fractures is reported to cause shoulder joint impairment. This retrospective study compared shoulder joint symptoms, range of motion (ROM), and isometric strength after antegrade IM nailing and dynamic compression (DC) plating of humeral shaft fractures. MATERIALS AND METHODS: We compared 29 patients with DC plating and 44 with antegrade IM nailing of their humeral shaft fractures. Shoulder pain, L'Insalata and Constant scores, shoulder joint ROM and isometric shoulder strengths were measured after mean follow-up of 6.2 (1-15) years (DC plating) and 5.5 (2-10) years (IM nailing). RESULTS:Patients had nonsignificantly more shoulder pain after IM nailing than after DC plating. Shoulder scores and isometric strength measurements showed no difference between the groups. Flexion was significantly better after DC plating, but none of the other ROM parameters differed between the groups. The shoulder scores and all ROM and strength parameters of the injured side were significantly lower than on the uninjured side in both groups. CONCLUSIONS: Shoulder joint ROM and strength does not recover to normal after humeral shaft fracture. Antegrade IM nailing if performed properly is not responsible for shoulder joint impairment.
Authors: Mir G R Wali; Asif N Baba; Irfan A Latoo; Nawaz A Bhat; Omar Khurshid Baba; Sudesh Sharma Journal: Strategies Trauma Limb Reconstr Date: 2014-11-19
Authors: Frank Joseph Paulus Beeres; Nicole van Veelen; Roderick Marijn Houwert; Björn Christian Link; Marilyn Heng; Matthias Knobe; Rolf Hendrik Herman Groenwold; Reto Babst; Bryan Joost Marinus van de Wall Journal: Eur J Trauma Emerg Surg Date: 2021-07-05 Impact factor: 2.374