OBJECTIVE: To use an ergonomics-based rating that characterizes both demand on, and capacity of, upper-extremity muscle groups during wheelchair propulsion to help identify the muscle groups most at risk for pain or overuse injury in a relatively demanding wheelchair propulsion task. DESIGN: Case series. SETTING: Biomechanics research laboratory. PARTICIPANTS: Sixteen manual wheelchair users with complete (American Spinal Injury Association grade A) T6-L2 paraplegia. INTERVENTIONS: Not applicable. MAIN OUTCOME MEASURES: Internal peak joint moments required by each of the major upper-extremity muscle groups for propelling a wheelchair up a ramp; isometric strength of each of the muscle groups in positions simulating wheelchair propulsion; and wheelchair propulsion strength rating (WPSR) for each muscle group, calculated by normalizing the joint demands to their capacity. RESULTS: The largest joint moment was for shoulder flexion, at 39.7+/-13.9Nm. Shoulder flexion also accounted for the peak WPSR value of 66.5%+/-20.3%. Supination and pronation movements had low peak moment requirements (3.4Nm, 5.0Nm, respectively) but high WPSR values (41%, 53%, respectively). CONCLUSIONS: Even a relatively benign ramp (2.9 degrees ) places a large demand on the musculature of the upper extremity, as assessed by using the WPSR to indicate muscular demand.
OBJECTIVE: To use an ergonomics-based rating that characterizes both demand on, and capacity of, upper-extremity muscle groups during wheelchair propulsion to help identify the muscle groups most at risk for pain or overuse injury in a relatively demanding wheelchair propulsion task. DESIGN: Case series. SETTING: Biomechanics research laboratory. PARTICIPANTS: Sixteen manual wheelchair users with complete (American Spinal Injury Association grade A) T6-L2 paraplegia. INTERVENTIONS: Not applicable. MAIN OUTCOME MEASURES: Internal peak joint moments required by each of the major upper-extremity muscle groups for propelling a wheelchair up a ramp; isometric strength of each of the muscle groups in positions simulating wheelchair propulsion; and wheelchair propulsion strength rating (WPSR) for each muscle group, calculated by normalizing the joint demands to their capacity. RESULTS: The largest joint moment was for shoulder flexion, at 39.7+/-13.9Nm. Shoulder flexion also accounted for the peak WPSR value of 66.5%+/-20.3%. Supination and pronation movements had low peak moment requirements (3.4Nm, 5.0Nm, respectively) but high WPSR values (41%, 53%, respectively). CONCLUSIONS: Even a relatively benign ramp (2.9 degrees ) places a large demand on the musculature of the upper extremity, as assessed by using the WPSR to indicate muscular demand.
Authors: Rungsinee Amanda Liusuwan; Lana M Widman; Richard Ted Abresch; Allan J Johnson; Craig M McDonald Journal: J Spinal Cord Med Date: 2007 Impact factor: 1.985
Authors: Shelby L Walford; Philip S Requejo; Sara J Mulroy; Richard R Neptune Journal: Clin Biomech (Bristol, Avon) Date: 2019-03-06 Impact factor: 2.063
Authors: Brooke A Slavens; Omid Jahanian; Alyssa J Schnorenberg; Elizabeth T Hsiao-Wecksler Journal: Med Eng Phys Date: 2019-07-05 Impact factor: 2.242
Authors: Laura Teeter; Julie Gassaway; Sally Taylor; Jacqueline LaBarbera; Shari McDowell; Deborah Backus; Jeanne M Zanca; Audrey Natale; Jordan Cabrera; Randall J Smout; Scott E D Kreider; Gale Whiteneck Journal: J Spinal Cord Med Date: 2012-11 Impact factor: 1.985