Lysine beta311 of protein geranylgeranyltransferase type I partially replaces magnesium.

Protein geranylgeranyltransferase type I (GGTase I) catalyzes the attachment of a geranylgeranyl lipid group near the carboxyl terminus of protein substrates. Unlike protein farnesyltransferase (FTase) and protein geranylgeranyltransferase type II, which require both Zn(II) and Mg(II) for maximal turnover, GGTase I turnover is dependent only on Zn(II). In FTase, the magnesium ion is coordinated by aspartate beta352 and the diphosphate of farnesyl diphosphate to stabilize the developing charge in the transition state (Pickett, J. S., Bowers, K. E., and Fierke, C. A. (2003) J. Biol. Chem. 278, 51243-51250). In GGTase I, lysine beta311 is substituted for this aspartate and is proposed to replace the catalytic function of Mg(II) (Taylor, J. S., Reid, T. S., Terry, K. L., Casey, P. J., and Beese, L. S. (2003) EMBO J. 22, 5963-5974). Here we demonstrate that the prenylation rate constant catalyzed by wild type GGTase I (k(chem) = 0.18 +/- 0.02 s(-1)) is not dependent on Mg(II), is approximately 20-fold slower than the maximal rate constant catalyzed by FTase, and has a single pKa of 6.4 +/- 0.1, likely reflecting deprotonation of the peptide thiol. Mutation of lysine beta311 in GGTase I to alanine (Kbeta311A) or aspartate (Kbeta311D) decreases the k(chem) in the absence of magnesium 9-41-fold without significantly affecting the binding affinity of either substrate. Furthermore, the geranylgeranylation rate constant is enhanced by the addition of Mg(II) for Kbeta311A and Kbeta311D GGTase I 2-5-fold compared with wild type GGTase I with K(Mg) of 140 +/- 10 mm and 6.4 +/- 0.8 mm, respectively. These results demonstrate that lysine beta311 of GGTase I partially replaces the catalytic function of Mg(II) observed in FTase.