Ytterbium-169: calculated physical properties of a new radiation source for brachytherapy.

Seeds containing radioactive Ytterbium-169 (169Yb) have recently been manufactured for possible application to brachytherapy. Ytterbium-169 emits photons with an average energy of 93 keV (excluding energies less than 10 keV), and decays with a half-life of 32 days. Analytic and Monte Carlo computations have been used to predict physical quantities useful in treatment planning and radiation protection. Analytic calculations based on the primary photon spectrum of 169Yb (excluding energies less than 10 keV) yield an air-kerma rate constant of 0.0427 cGy cm2 h-1 MBq-1, and an exposure rate constant of 1.80 R cm2 mCi-1 h-1 for this radionuclide. Calculated fmed factors are 0.922 cGy/R for soft tissue and 2.12 cGy/R for bone. The first half-value layer in lead is 0.2 mm; the first tenth-value layer is 1.6 mm. Using Monte Carlo simulations, the relative dose distributions around 169Yb seeds (Amersham, prototypes 4 and 5) are provided, and are then compared with those around an 125I seed (3M model 6702). The 169Yb seeds produce more isotropic dose distributions, and for permanent implants, can deliver it at a greater initial dose rate. A value of 1.19 cm-2 was also calculated for the specific dose constant D0, a value which is applicable to both seed types. Radiation protection is not as easily achieved for permanent implants with 169Yb because of the higher energy emissions (vs 125I). However, for temporary implants, Ytterbium-169 may prove to be a useful substitute for 192Ir or 137Cs because of its relatively lower energy emissions. It is concluded that 169Yb merits further investigation, including dosimetry, radiobiological, and clinical studies.