Preparation and characterization of solid lipid nanoparticles containing peptide.

Solid lipid nanoparticles (SLN) are an alternative colloidal carrier system for controlled drug delivery. However, only a few have been studied regarding the incorporation of peptides into SLN, due to the hydrophilic peptide not easy to enter the lipophilic matrix of SLN. In the present report, peptide-loaded solid lipid nanoparticles were prepared by a novel solvent diffusion method in an aqueous system. The model peptide gonadorelin was incorporated to study the entrapment efficiency, size, zeta potential (charge) and drug delivery characterization. Gonadorelin and monostearin were dissolved in acetone and ethanol at 50 degrees C in water bath, the resultant organic solution was poured into an aqueous containing 1% polyvinyl alcohol (PVA) under mechanical agitation. The peptide-loaded solid lipid nanoparticles were quickly produced and separated by centrifugation. The average volume diameter of gonadorelin-loaded SLN is 421.7 nm and the zeta potential of SLN is -21.1 mV dispersed in distilled water. Up to 69.4% of gonadorelin can be incorporated. In vitro release of gonadorelin from SLN is slow. In the test solution of a 0.1N hydrochloric acid for 2h and then transferred in a pH 6.8 phosphate buffer (simulative gastrointestinal fluid), the drug-release behavior from SLN suspension exhibited a biphasic pattern. After burst drug-release at the first 6h at a percentage of 24.4% of loaded gonadorelin, a distinctly prolonged release over a monitored period of 12 days was observed and nearly 3.81% of drug was released in each day. In the test solution of a pH 6.8 phosphate buffer (simulative intestinal fluid), the drug-release rate from SLN was similar to that in the simulative gastrointestinal fluid. Further, a novel preparation method in the present research for peptide-loaded SLN was established. These results also demonstrate the principle suitability of SLN as a prolonged release formulation for hydrophilic peptide drugs.