Effect of surface treatment of prefabricated posts on bonding of resin cement.

This in vitro study evaluated the effect of various surface treatments of prefabricated posts of titanium alloy (ParaPost XH), glass fiber (ParaPost Fiber White) and zirconia (Cerapost) on the bonding of two resin cements: ParaPost Cement and Panavia F by a diametral tensile strength (DTS) test. The posts received surface treatments in three categories: 1) roughening by sandblasting and hydrofluoric acid etching; 2) application of primer by coating with Alloy Primer, Metalprimer II and Silane and 3) a combination treatment in the form of roughening (sandblasting or etching) supplemented by the application of a primer or in the form of the Cojet system. After surface treatment, the post was embedded in a cylinder of resin cement (diameter = 4.0 mm, height = 4.0 mm). The surface-treated post was centered in the resin cement-filled mold with the aid of fixation apparatus. Fifteen minutes from the start of mixing the resin cement, the specimen was freed from the mold and stored in water at 37 degrees C for seven days. Following water storage, the specimen was wet-ground to a final length of approximately 3 mm. The DTS of specimens was determined in a Universal Testing Machine. The bonding of resin cement to titanium alloy posts was increased by several surface treatments of the post. However, coating with primers as sole treatment had no effect on bonding. With the DTS method applied, none of the surface treatments had an effect on the bonding to glass fiber posts. The bonding of both resin cements to zirconia posts was improved by Cojet treatment, while sandblasting, followed by silane application, improved bonding of Panavia F.