Literature DB >> 14706321

Experimental and theoretical investigation of directional permeability of human vertebral cancellous bone for cement infiltration.

G Baroud1, R Falk, M Crookshank, S Sponagel, T Steffen.   

Abstract

The use of acrylic polymers in infiltrating the porous bone structure is an emerging procedure for the augmentation of osteoporotic vertebrae. Although this procedure is employed frequently, it is performed based on empirical knowledge, and therefore, does not take into consideration the porosity-dependent permeability of human vertebral cancellous bone. The purpose of this study was to: (a). experimentally and theoretically investigate interdependence of the vertebral cancellous bone permeability and porosity, and (b). examine if the bone permeability of spinal cancellous bone can be predicted using bone mineral density measurements. If these relations can be established, they can be useful in optimizing the injection conditions for predicable cement infiltration. To determine the porosity-dependent and directional permeability, 34 bone cores-20 samples in the superior-inferior (SI) direction and 14 in the anterior-posterior (AP) direction-were cut from 20 lumbar vertebrae and infiltrated with silicone oil with a viscosity matching that of PMMA. The permeability of the cores was determined based on Darcy's law. The mean permeability of SI and AP cores was 4.45+/-1.72 x 10(-8) and 3.44+/-1.26 x 10(-8)m(2), respectively. An interesting finding of this study was that the permeability of the AP cores was approximately 78% of that of SI cores, though the porosity of the SI and AP cores taken from the same vertebra was approximately equal. In addition, we provided a theoretical model for the porosity-dependent permeability that accurately described non-linear dependency of the bone permeability and porosity in both directions. Although the relation of the bone permeability and porosity was established, bone mineral density was a weak predictor of the bone permeability. The experimental and theoretical results of this study can be used to understand polymer flow in cement infiltration procedures.

Entities:  

Mesh:

Substances:

Year:  2004        PMID: 14706321     DOI: 10.1016/s0021-9290(03)00246-x

Source DB:  PubMed          Journal:  J Biomech        ISSN: 0021-9290            Impact factor:   2.712


  11 in total

1.  A new cannula to ease cement injection during vertebroplasty.

Authors:  G Baroud; T Steffen
Journal:  Eur Spine J       Date:  2005-01-26       Impact factor: 3.134

2.  Fabric dependence of quasi-waves in anisotropic porous media.

Authors:  Luis Cardoso; Stephen C Cowin
Journal:  J Acoust Soc Am       Date:  2011-05       Impact factor: 1.840

3.  Fabric dependence of wave propagation in anisotropic porous media.

Authors:  Stephen C Cowin; Luis Cardoso
Journal:  Biomech Model Mechanobiol       Date:  2010-05-12

4.  Comparison of failure mechanisms for cements used in skeletal luting applications.

Authors:  O Clarkin; D Boyd; M R Towler
Journal:  J Mater Sci Mater Med       Date:  2009-03-13       Impact factor: 3.896

5.  Cement leakage and filling pattern study of low viscous vertebroplastic versus high viscous confidence cement.

Authors:  Mohamed Habib; Hassan Serhan; Connie Marchek; Gamal Baroud
Journal:  SAS J       Date:  2010-03-01

6.  Computationally designed lattices with tuned properties for tissue engineering using 3D printing.

Authors:  Paul F Egan; Veronica C Gonella; Max Engensperger; Stephen J Ferguson; Kristina Shea
Journal:  PLoS One       Date:  2017-08-10       Impact factor: 3.240

Review 7.  A Review of PMMA Bone Cement and Intra-Cardiac Embolism.

Authors:  Puneeth Shridhar; Yanfei Chen; Ramzi Khalil; Anton Plakseychuk; Sung Kwon Cho; Bryan Tillman; Prashant N Kumta; YoungJae Chun
Journal:  Materials (Basel)       Date:  2016-10-06       Impact factor: 3.623

8.  Estimation of anisotropic permeability in trabecular bone based on microCT imaging and pore-scale fluid dynamics simulations.

Authors:  C Daish; R Blanchard; K Gulati; D Losic; D Findlay; D J E Harvie; P Pivonka
Journal:  Bone Rep       Date:  2016-12-16

9.  Mechanical properties and fluid permeability of gyroid and diamond lattice structures for intervertebral devices: functional requirements and comparative analysis.

Authors:  Anatolie Timercan; Vadim Sheremetyev; Vladimir Brailovski
Journal:  Sci Technol Adv Mater       Date:  2021-04-21       Impact factor: 8.090

10.  Computer Simulation and Analysis on Flow Characteristics and Distribution Patterns of Polymethylmethacrylate in Lumbar Vertebral Body and Vertebral Pedicle.

Authors:  Da Liu; Xu-Li Liu; Bo Zhang; Dong-Fa Liao; Zhi-Qiang Li; Jiang-Jun Zhou; Xia Kang; Wei Zheng; Wei Lei
Journal:  Biomed Res Int       Date:  2015-12-07       Impact factor: 3.411

View more

北京卡尤迪生物科技股份有限公司 © 2022-2023.