Effect of femoral component design on unresurfaced patellas in knee arthroplasty.

Three total knee designs were evaluated to test the hypothesis that femoral component design affects the clinical and mechanical functions of the unresurfaced patella after total knee arthroplasty. Patients with the Ortholoc II, Advantim, and Profix femoral components were followed up for as many as 14 years and revision rate, anterior knee pain, and generalized knee pain were compared. A laboratory protocol was devised to evaluate pressure in the patellofemoral joint of knees from cadavers with a pressure-sensitive transducer using the same three designs at various degrees of knee flexion. Thirty Ortholoc II knee components were followed up for 14 years. Nineteen patients (63%) had severe anterior knee pain and 15 patients (50%) had reoperation to resurface the patella within 2 years. Two hundred one patients (222 knees) with Advantim components were followed up for 10 years and 305 patients (330 knees) with Profix components were followed up for 5 years. No patients with these two knee designs had severe anterior knee pain or reoperation for patellar resurfacing. A significantly higher rate of mild anterior knee pain was seen in the patients with Advantim components than in the patients with Profix components. No apparent relationship was seen between the severity of patellar wear found at the time of surgery and the incidence of anterior knee pain. Patients with rheumatoid arthritis receiving either the Advantim or Profix knee component performed as well as patients with osteoarthritis when the patella was not resurfaced. Pressure was significantly higher in the patellofemoral joints of the laboratory knee specimens with Ortholoc II components than in the specimens with either the Advantim or Profix components. The specimens with Advantim components had significantly higher pressure than did the specimens with normal knees, and the specimens with Profix components differed little from those with normal knees.