Adhesive bonding of titanium-aluminum-niobium alloy with nine surface preparations and three self-curing resins.

The purpose of the current study was to evaluate the adhesive performance of metal conditioners when used for bonding between auto-polymerizing methacrylic resins and a titanium alloy. Disk specimens were cast from a titanium-aluminum-niobium (Ti-6Al-7Nb) alloy, air-abraded with alumina, and bonded with 24 combinations of eight metal conditioners (Acryl Bond, ACB; All-Bond 2 Primer B, ABB; Alloy Primer, ALP; Cesead II Opaque Primer, COP; Metafast Bonding Liner, MBL; Metal Primer II, MPII; MR Bond, MRB; Super-Bond liquid, SBL) and three autopolymerizing methacrylic resins (Repairsin, RE; Super-Bond C & B, SB; Tokuso Rebase; TR). Unprimed specimens were used as controls. Shear bond strengths were determined both before and after thermocycling (4-60 degrees C, 20, 000 cycles). The ALP-SB group recorded the greatest post-thermocycling bond strength (21.8 MPa) followed by the COP-SB group (17.8 MPa) and the MPII-SB group. The post-thermocycling bond strengths of the unprimed-SB group and the ALP-RE group were statistically comparable. No significant differences were found among the nine TR resin groups, and these groups showed the lowest bond strength. In conclusion, the use of one of the three conditioners (ALP, COP, and MPII) in combination with the SB resin is recommended for bonding the Ti-6Al-7Nb alloy.