Literature DB >> 12562067

Comparison of the effects of patellar tendon bearing and total surface bearing sockets on prosthetic fitting and rehabilitation.

K Yiğiter1, G Sener, K Bayar.   

Abstract

Patellar tendon bearing (PTB) and total surface bearing (TSB) sockets have been used respectively in the prosthetic treatment of 20 trans-tibial amputees to investigate the effectiveness of both sockets on prosthetic fitting and rehabilitation. Data analysis showed that prostheses with TSB sockets were lighter than the prostheses with PTB sockets and better suspension was obtained from TSB prosthetic socket (p<0.05). It was also found that weight acceptance on the amputated side advanced to a more normal value with TSB prostheses (p<0.05). There was a statistically significant difference between the two socket types in walking and in other ambulation activities except sitting and standing up from a chair, in favour of the TSB socket (p<0.05). Consequently, due to the outcome of this study it can be said that TSB prosthetic sockets can be used effectively in the rehabilitation of trans-tibial amputees.

Entities:  

Mesh:

Year:  2002        PMID: 12562067     DOI: 10.1080/03093640208726649

Source DB:  PubMed          Journal:  Prosthet Orthot Int        ISSN: 0309-3646            Impact factor:   1.895


  9 in total

1.  Developing a control framework for self-adjusting prosthetic sockets incorporating tissue injury risk estimation and generalized predictive control.

Authors:  F M Mbithi; A J Chipperfield; J W Steer; A S Dickinson
Journal:  Biomed Eng Lett       Date:  2021-12-02

2.  Mapping Lower-Limb Prosthesis Load Distributions Using a Low-Cost Pressure Measurement System.

Authors:  Matthew O Hopkins; Shruti Turner; Ravi Vaidyanathan; Alison McGregor
Journal:  Front Med Technol       Date:  2022-06-17

3.  A simulation-based analysis of the effects of variable prosthesis stiffness on interface dynamics between the prosthetic socket and residual limb.

Authors:  Michael A McGeehan; Peter G Adamczyk; Kieran M Nichols; Michael E Hahn
Journal:  J Rehabil Assist Technol Eng       Date:  2022-07-15

4.  Gait biomechanics of individuals with transtibial amputation: effect of suspension system.

Authors:  Arezoo Eshraghi; Noor Azuan Abu Osman; Mohammad Karimi; Hossein Gholizadeh; Ehsan Soodmand; Wan Abu Bakar Wan Abas
Journal:  PLoS One       Date:  2014-05-27       Impact factor: 3.240

5.  Comparative study between Dermo, Pelite, and Seal-In X5 liners: effect on patient's satisfaction and perceived problems.

Authors:  Sadeeq Ali; Noor Azuan Abu Osman; Nooranida Arifin; Hossein Gholizadeh; Nasrul Anwar Abd Razak; Wan Abu Bakar Wan Abas
Journal:  ScientificWorldJournal       Date:  2014-08-11

6.  A comparison between the dimensions of positive transtibial residual limb molds prepared by air pressure casting and weight-bearing casting methods.

Authors:  Behnam Hajiaghaei; Ismail Ebrahimi; Mojtaba Kamyab; Hassan Saeedi; Maryam Jalali
Journal:  Med J Islam Repub Iran       Date:  2016-03-08

7.  Design and evaluation of a prosthetic socket for a patient with diabetic-related transtibial amputation: A case report.

Authors:  Batoul Bagheripour; Mohammad Ali Mardani; Behnam Hajiaghaei; Akbar Biglarian; Taher Babaee; Hamid Pezham
Journal:  Clin Case Rep       Date:  2022-09-08

8.  Hands-off and hands-on casting consistency of amputee below knee sockets using magnetic resonance imaging.

Authors:  Mohammad Reza Safari; Philip Rowe; Angus McFadyen; Arjan Buis
Journal:  ScientificWorldJournal       Date:  2013-11-19

Review 9.  Techniques for Interface Stress Measurements within Prosthetic Sockets of Transtibial Amputees: A Review of the Past 50 Years of Research.

Authors:  Ebrahim A Al-Fakih; Noor Azuan Abu Osman; Faisal Rafiq Mahmad Adikan
Journal:  Sensors (Basel)       Date:  2016-07-20       Impact factor: 3.576

  9 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.