Effect of silane primers and unfilled resin bonding agents on repair bond strength of a prosthodontic microfilled composite.

This study examined the effect of silane primers and bonding agents on bonding between layers of a light-activated composite material when repaired in the laboratory process. Disk specimens were prepared with the dentin portion of a composite material (Dentacolor DA-30) and abraded with a silicon carbide rotary cutting instrument. The specimens were conditioned with either one of the two silane primers (Porcelain Liner M and Silicer) or one of the two unfilled resin bonding agents (Dentacolor Opaker liquid and New Metacolor Photo Opaque liquid), or one of four combinations of two primers and two bonding agents. An intact surface with a thin air-inhibited unpolymerized layer, and an unprimed surface with only silicone carbide abrasion were also used for references. After placement of the enamel portion of the same brand of composite material (Dentacolor SA-30) on each surface of the dentin material, the specimens were light-exposed, and stored for 24 h in either dry or wet condition. Shear bond strengths were then determined with a mechanical testing device. The results showed that combined use of a silane primer and a bonding agent generally showed the greatest magnitude of bond strength regardless of material variation. The use of an unfilled resin bonding agent after application of a silane primer (Porcelain Liner M) is recommended to ensure adequate repair bonding between layers of the composite material.