Sphingomyelinase cleavage of sphingomyelin in pure and mixed lipid membranes. Influence of the physical state of the sphingolipid.

Sphingomyelin hydrolysis by sphingomyelinase is essential in regulating membrane levels of ceramide, a well-known metabolic signal. Since natural sphingomyelins have a gel-to-fluid transition temperature in the range of the physiological temperatures of mammals and birds, it is important to understand the influence of the physical state of the lipid on the enzyme activity. With that aim, large unilamellar vesicles consisting of pure egg sphingomyelin (gel-to-fluid crystalline transition temperature ca. 39 degrees C) were treated with sphingomyelinase in the temperature range 10-70 degrees C. The vesicles were also examined by differential scanning calorimetry (DSC). Shingomyelinase was active on pure sphingomyelin bilayers, leading to concomitant lipid hydrolysis, vesicle aggregation, and leakage of aqueous liposomal contents. Enzyme activity was found to be much higher when the substrate was in the fluid than when it was in the gel state. Sphingomyelinase activity was found to exhibit lag times, followed by bursts of activity. Lag times decreased markedly when the substrate went from the gel to the fluid state. When egg phosphatidylcholine, or egg phosphatidylethanolamine were included in the bilayer composition together with sphingomyelin, sphingomyelinase activity at 37 degrees C, that was negligible for the pure sphingolipid bilayers, was seen to increase with the proportion of glycerophospholipid, while the latency times became progressively shorter. A DSC study of the mixed-lipid vesicles revealed that both phosphatidylcholine and phosphatidyletanolamine decreased in a dose-dependent way the transition temperature of sphingomyelin. Thus, as those glycerophospholipids were added to the membrane composition, the proportion of sphingomyelin in the fluid state at 37 degrees C increased accordingly, in this way becoming amenable to rapid hydrolysis by the enzyme. Thus sphingomyelinase requires the substrate in bilayer form to be in the fluid state, irrespective of whether this is achieved through a thermotropic transition or by modulating bilayer composition.