Accuracy and precision of bone mineral density and bone mineral content in excised rat humeri using fan beam dual-energy X-ray absorptiometry.

The aim of this study was the evaluation of fan beam dual-energy X-ray absorptiometry (DXA) for measuring bone mineral density (BMD) and bone mineral content (BMC) of isolated rat humeri. Defleshed rat humeri from male Lewis rats were examined with a Hologic QDR 4500 A (Hologic, Inc., Bedford, MA) high-resolution densitometer both in water and 0.9% saline solution. The small animal scan protocol with the regional high-resolution mode was used. BMC measured by DXA was compared with bone dry weight, ash weight, and bone calcium content. Furthermore, DXA BMD and BMC precision were determined. We also evaluated the effect of salinity of the water bath in which the bones were measured. Correlations (r(2)) of BMC, as determined by DXA with dry weight, ash weight, and bone calcium content, were 0.978, 0.988, and 0.890, respectively. DXA overestimated ash weight by 5%-9%. Precision errors for BMC (BMD) were 0.90% (0.76%) without and 1.3 (0.86) with repositioning. Changes in the salinity of the water bath had a significant influence on the DXA results: At the 0.9% physiological level, BMC (-4.4%) and area (-4.1%), but not BMD, values were significantly lower (p < 0.005) compared with measurements in tap water. Fan beam DXA is a highly accurate and precise technique for measuring BMC and BMD in excised small animal bones. A physiological saline concentration in the water bath had a significant impact on BMC and area, but not on BMD, and should therefore be strictly controlled to avoid an underestimation of BMC.