Literature DB >> 11745552

Bone response to radio frequency sputtered calcium phosphate implants and titanium implants in vivo.

J L Ong1, K Bessho, R Cavin, D L Carnes.   

Abstract

The objective of this study was to evaluate the effect of radio frequency sputtered calcium phosphate (CaP) coatings of titanium (Ti) implants on the bond strength at the bone-implant interface and percent bone contact length. Cylindrical coated or noncoated implants (4.0-mm diameter by 8-mm long) were implanted for 3 and 12 weeks. At 3 weeks after implant placement, the ultimate interfacial strengths for as-deposited CaP-coated and heat-treated CaP-coated implants were 2.29 +/- 0.14 MPa and 1.28 +/- 0.04 MPa, respectively. These ultimate interfacial strength values at 3 weeks were statistically greater than the mean ultimate interfacial strength for control Ti implants (0.67 +/- 0.13 MPa). At 12 weeks after implant placement, no statistical differences in the mean ultimate interfacial strengths were observed between the as-deposited CaP-coated, heat-treated CaP-coated, and control Ti implants. Histomorphometric evaluation indicated greater percent bone contact lengths for the as-deposited CaP-coated implants compared with the heat-treated CaP-coated and control Ti implants 3 and 12 weeks after implant placement. Copyright 2001 John Wiley & Sons, Inc.

Entities:  

Mesh:

Substances:

Year:  2002        PMID: 11745552     DOI: 10.1002/jbm.1232

Source DB:  PubMed          Journal:  J Biomed Mater Res        ISSN: 0021-9304


  4 in total

1.  Calcium orthophosphate coatings, films and layers.

Authors:  Sergey V Dorozhkin
Journal:  Prog Biomater       Date:  2012-09-26

2.  Calcium phosphate thin films enhance the response of human mesenchymal stem cells to nanostructured titanium surfaces.

Authors:  Mura M McCafferty; George A Burke; Brian J Meenan
Journal:  J Tissue Eng       Date:  2014-05-27       Impact factor: 7.813

3.  Comparative Study on 3D Printed Ti6Al4V Scaffolds with Surface Modifications Using Hydrothermal Treatment and Microarc Oxidation to Enhance Osteogenic Activity.

Authors:  Leizhen Huang; Bianyun Cai; Yong Huang; Jingcheng Wang; Ce Zhu; Kun Shi; Yueming Song; Ganjun Feng; Limin Liu; Li Zhang
Journal:  ACS Omega       Date:  2021-01-07

4.  Facile Fabrication of 3D-Printed Porous Ti6Al4V Scaffolds with a Sr-CaP Coating for Bone Regeneration.

Authors:  Shenghui Su; Weidong Chen; Minghui Zheng; Guozan Lu; Wei Tang; Haihong Huang; Dongbin Qu
Journal:  ACS Omega       Date:  2022-03-01
  4 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.