Visualization of the stop of microtubule depolymerization that occurs at the high-density region of microtubule-associated protein 2 (MAP2).

Individual microtubules (MTs) repeat alternating phases of polymerization and depolymerization, a process known as dynamic instability. Microtubule-associated proteins (MAPs) regulate the dynamic instability by increasing the rescue frequency. To explore the influence of MAP2 on in vitro MT dynamics, we correlated the distribution of MAP2 on individual MTs with the dynamic phase changes of the same MTs. MAP2 was modified selectively on its projection region by X-rhodamine iodoacetamide without altering the MT-binding activity. When the labeled MAP2 was added to MTs, the fluorescence was distributed along almost the entire length of individual MTs. However, the inhomogeneity of the distribution gradually became obvious due to the fluorescence bleaching, and the MTs appeared to consist of rapidly bleached portions (RBPs) and slowly bleached portions (SBPs), which were distributed randomly along the MT. By measuring the duration of fluorescence bleaching, the density of MAP2 in SBP was estimated to be approximately 2.5 times higher than the RBP. The average tubulin:MAP2 ratio in SBP was calculated to be 16. When the MT dynamics were observed by dark-field microscopy after determining the MAP2 distribution, rescues were always found to occur only at the SBPs. MTs also displayed intermittent shortening by repeated depolymerization phases separated by pause phases. In these cases, depolymerization phases stopped only at the SBPs. Not every SBP stopped depolymerization, but depolymerization always stopped at an SBP. Taken together, we suggest that there is a minimum density of MAP2 that is necessary to stop depolymerization. Copyright 2001 Academic Press.