Literature DB >> 10075157

The stability and immunogenicity of a protein antigen encapsulated in biodegradable microparticles based on blends of lactide polymers and polyethylene glycol.

E C Lavelle1, M K Yeh, A G Coombes, S S Davis.   

Abstract

Protein-loaded microparticles were produced from blends of poly(ethylene glycol) (PEG) with poly(L-lactide) (PLA) homopolymer or poly(DL-lactide co-glycolide) copolymers (PLG) using a water-in oil-in oil method. The stability of ovalbumin (OVA) associated with microparticles prepared using PEG and 50:50 PLG, 75:25 PLG and PLA, respectively, was analysed by SDS-PAGE and quantified by scanning densitometry following incubation in PBS at 37 degrees C for up to 1 month. Fragmentation and aggregation of OVA was detected with all 3 formulations. The extent of both processes correlated with the degradation rate of the lactide polymer used and decreased in the order PLA < 75:25 PLG < 50:50 PLG. Extensive degradation of the PLG/PEG microparticles also occurred over 4 weeks whereas the use of PLA/PEG blends resulted in a stable microparticle morphology and much reduced fragmentation and aggregation of the associated protein. Following a single sub-cutaneous immunisation, high levels of specific serum IgG antibody were elicited by OVA associated with the PLA/PEG particles. Injection of OVA associated with the 75:25 PLG/PEG microparticles resulted in very low levels of specific antibody. A higher response was induced by the 50:50 PLG/PEG formulation but there was very large inter-animal variation in this group. Antibody levels elicited by all 3 formulations were significantly higher than those elicited by a single injection of soluble OVA. Analysis of antigen specific IgG1 and IgG2a antibody subtype levels also revealed the greater efficacy of the PLA/PEG microparticles as an adjuvant system. The use of PLA/PEG microparticles shows improved protein loading and delivery capacity while maintaining a high level of stability of the associated protein. These results indicate a strong correlation between the stability of microencapsulated antigen and the magnitude of the immune response following sub-cutaneous immunisation.

Entities:  

Mesh:

Substances:

Year:  1999        PMID: 10075157     DOI: 10.1016/s0264-410x(98)00229-1

Source DB:  PubMed          Journal:  Vaccine        ISSN: 0264-410X            Impact factor:   3.641


  8 in total

1.  The microclimate pH in poly(D,L-lactide-co-hydroxymethyl glycolide) microspheres during biodegradation.

Authors:  Yajun Liu; Amir H Ghassemi; Wim E Hennink; Steven P Schwendeman
Journal:  Biomaterials       Date:  2012-07-21       Impact factor: 12.479

2.  Stabilization and controlled release of bovine serum albumin encapsulated in poly(D, L-lactide) and poly(ethylene glycol) microsphere blends.

Authors:  W Jiang; S P Schwendeman
Journal:  Pharm Res       Date:  2001-06       Impact factor: 4.200

3.  Lysozyme release and polymer erosion behavior of injectable implants prepared from PLGA-PEG block copolymers and PLGA/PLGA-PEG blends.

Authors:  Vesna Milacic Vesna Milacic; Steven P Schwendeman
Journal:  Pharm Res       Date:  2014-02       Impact factor: 4.200

4.  Effect of additives on the release of a model protein from PLGA microspheres.

Authors:  F Kang; J Singh
Journal:  AAPS PharmSciTech       Date:  2001-12-17       Impact factor: 3.246

5.  Acidic microclimate pH distribution in PLGA microspheres monitored by confocal laser scanning microscopy.

Authors:  Amy G Ding; Steven P Schwendeman
Journal:  Pharm Res       Date:  2008-07-12       Impact factor: 4.200

Review 6.  Polymer-based sustained-release dosage forms for protein drugs, challenges, and recent advances.

Authors:  Fei Wu; Tuo Jin
Journal:  AAPS PharmSciTech       Date:  2008-12-16       Impact factor: 3.246

7.  Intranasal M cell uptake of nanoparticles is independently influenced by targeting ligands and buffer ionic strength.

Authors:  Thejani E Rajapaksa; Kaila M Bennett; Mary Hamer; Christian Lytle; Victor G J Rodgers; David D Lo
Journal:  J Biol Chem       Date:  2010-05-28       Impact factor: 5.157

8.  Immunogenicity of pulsatile-release PLGA microspheres for single-injection vaccination.

Authors:  Rohiverth Guarecuco; Jennifer Lu; Kevin J McHugh; James J Norman; Lavanya S Thapa; Emily Lydon; Robert Langer; Ana Jaklenec
Journal:  Vaccine       Date:  2017-06-19       Impact factor: 3.641

  8 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.