Literature DB >> 9842832

A comparison of pharyngeal mucosal pressure and airway sealing pressure with the laryngeal mask airway in anesthetized adult patients.

J Brimacombe1, C Keller.   

Abstract

UNLABELLED: We measured pharyngeal mucosal pressures at six different locations on the laryngeal mask airway (LMA) and tested the hypothesis that the efficacy of the seal is not related to pharyngeal mucosal pressure. Twenty anesthetized, paralyzed adult patients were studied. Microchip sensors were attached to the size 5 LMA at locations corresponding to the lateral and posterior pharynx, the hypopharynx, the pyriform fossa, the base of tongue, and the oropharynx. Mucosal pressures and airway sealing pressures were recorded during inflation of the cuff from 0 to 40 mL in 10-mL increments. The highest mean mucosal pressure was in the oropharynx (26 cm H2O), and the lowest was in the posterior pharynx (2 cm H2O). Mucosal pressures increased with increasing intracuff pressure and cuff volume, but the rate of increase varied among locations. Airway sealing pressure increased with increasing intracuff volume from 0 to 10 mL (P < 0.0001) and 10 to 20 mL (P = 0.0001), was unchanged from 20 to 30 mL, and decreased from 30 to 40 mL (P = 0.005). The airway sealing pressure was higher than pharyngeal mucosal pressure until the intracuff volume was > or =30 mL. There was no correlation between mucosal pressures and airway sealing pressure at any location. We conclude that the efficacy of the seal is not related to pharyngeal mucosal pressure. Pharyngeal mucosal pressures are generally lower than those considered safe for the tracheal mucosa during prolonged intubation. IMPLICATIONS: We measured pharyngeal mucosal pressures at six different locations on the laryngeal mask airway and showed that the efficacy of the seal is not related to pharyngeal mucosal pressure. Pharyngeal mucosal pressures are generally lower than those considered safe for the tracheal mucosa during prolonged intubation.

Entities:  

Mesh:

Year:  1998        PMID: 9842832     DOI: 10.1097/00000539-199812000-00032

Source DB:  PubMed          Journal:  Anesth Analg        ISSN: 0003-2999            Impact factor:   5.108


  3 in total

1.  Superior sealing effect of a three-dimensional printed modified supraglottic airway compared with the i-gel in a three-dimensional printed airway model.

Authors:  Tomohiko Kimijima; Mitsutaka Edanaga; Michiaki Yamakage
Journal:  J Anesth       Date:  2018-07-18       Impact factor: 2.078

2.  Comparison of the effects of room air and N2O + O2 used for ProSeal LMA cuff inflation on cuff pressure and oropharyngeal structure.

Authors:  Murat Tekin; Ismail Kati; Yakup Tomak; Koksal Yuca
Journal:  J Anesth       Date:  2008-11-15       Impact factor: 2.078

3.  Cobra-PLA provides higher oropharyngeal leak pressure than LMA-Classic and LMA-Unique: A meta-analysis with 22 studies.

Authors:  Yuan Tan; Guangyou Duan; Qin Chen; Feng Chen; Hong Li
Journal:  Medicine (Baltimore)       Date:  2019-06       Impact factor: 1.817

  3 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.