Factors influencing the diffusion-controlled release of papaverine from poly (L-lactic acid) matrix.

Effects of drug content and medium pH on the release of papaverine (PAP) from biodegradable poly(l-lactic acid) [P(L)LA] matrix were investigated to reveal the predominant factors affecting the two-stage diffusion-controlled release mechanism. A drug-dissolved cylindrical matrix (rod; 10 mmx1 mm diameter) was prepared by heat compression method. In the case of a PAP content below 10%, pH was found to have a strong effect on the release rate, and drug content was found to have no effect on the release profile. The release profile consisted of two sequential diffusion stages due to P(L)LA transformation from amorphous to the semicrystalline state prior to release. In the first release stage PAP diffused through the swollen matrix. The release accelerated with increasing medium pH due to an increase in water content in the acidic P(L)LA rod. In the second release stage PAP diffused through the water-filled micropores developed as a result of the polymer crystallization. On the assumption that the drug partition between the polymer and the medium in the micropores affects the diffusion and the partition is controlled by pH, we derived a modified diffusion kinetic equation. The observation that the release decelerated with increasing medium pH can be explained by the derived equation as resulting from the increase in the drug partition to the polymer. In the case where the rods contained more than 15% of PAP, the drug precipitated out as crystals during release. Accordingly, these rods showed a slower release.