Literature DB >> 9680451

Polymer Brushes: From Self-Consistent Field Theory to Classical Theory.

.   

Abstract

We consider planar brushes formed by end-grafted polymers with moderate to strong excluded-volume interactions. We first rederive the mean-field theory and solve the resulting self-consistent equations numerically. In the continuum limit, the results depend sensitively on a single parameter, beta, whose square is the ratio of the scaling prediction for the brush height to the unperturbed polymer radius of gyration, and which measures therefore the degree to which the polymers are stretched. For large values of beta, the density profile is close to parabolic, as predicted by the infinite-stretching theory of Zhulina et al. and of Milner et al. As beta decreases, the profile deviates strongly from a parabolic one. By calculating the most probable paths and comparing their contribution to various properties with those obtained from the full self-consistent theory, we determine the effect of the fluctuations about such paths. At large values of beta, these effects are very small everywhere. As beta decreases, fluctuation effects on the density profile become increasingly important near the grafting surface, but remain small far from it. For all values of beta, we find that polymer paths which begin far from the grafting surface are strongly, and almost uniformly, stretched throughout their length, including their free end points. Paths which begin close to the grafting surface are also stretched, but they initially move away from the grafting surface before reaching a maximum height and then returning to it. The classical theory is then derived from the self-consistent field equations by retaining, for each end point location, only that single trajectory which minimizes the free energy of the system. This free energy contains an entropy, of relative weight beta-1, which arises from the distribution of end points. Even for brushes which are only moderately stretched, the results of the classical theory for the brush profile and polymer end point distribution agree well with those of the full self-consistent theory except near the grafting surface itself. There the density profile as calculated in the self-consistent theory shows a characteristic decrease which is not captured by the classical theory. However it does capture the fact that the individual polymer paths are stretched in general throughout their length, including the end points, and yields nonmonotonic paths for polymers whose end points are close to the grafting surface. In addition, it reproduces extremely well the form of the density distribution far from the grafting surface, which is essentially Gaussian. This results from the fact that the stretching energy dominates the interaction energy of those polymers which extend far from the grafting surface, so that their behavior is nearly ideal. In the limit of infinite stretching, beta --> infinity, the theory reduces to that of Zhulina et al. and of Milner et al.

Entities:  

Year:  1998        PMID: 9680451     DOI: 10.1021/ma9717505

Source DB:  PubMed          Journal:  Macromolecules        ISSN: 0024-9297            Impact factor:   5.985


  10 in total

1.  Solid phase DNA amplification: a simple Monte Carlo Lattice model.

Authors:  Jean-Francois Mercier; Gary W Slater; Pascal Mayer
Journal:  Biophys J       Date:  2003-10       Impact factor: 4.033

2.  Effect of salt on the compression of polyelectrolyte brushes in a theta solvent.

Authors:  M W Matsen
Journal:  Eur Phys J E Soft Matter       Date:  2012-02-27       Impact factor: 1.890

3.  Strong-segregation limit of the self-consistent field theory for diblock copolymer melts.

Authors:  M W Matsen
Journal:  Eur Phys J E Soft Matter       Date:  2010-11-25       Impact factor: 1.890

4.  Solid phase DNA amplification: a Brownian dynamics study of crowding effects.

Authors:  Jean-François Mercier; Gary W Slater
Journal:  Biophys J       Date:  2005-04-08       Impact factor: 4.033

5.  Finite-stretching corrections to the Milner-Witten-Cates theory for polymer brushes.

Authors:  J U Kim; M W Matsen
Journal:  Eur Phys J E Soft Matter       Date:  2007-06       Impact factor: 1.890

6.  Simulation and modelling of slip flow over surfaces grafted with polymer brushes and glycocalyx fibres.

Authors:  Mingge Deng; Xuejin Li; Haojun Liang; Bruce Caswell; George Em Karniadakis
Journal:  J Fluid Mech       Date:  2012-11-01       Impact factor: 3.627

7.  Macroscopic lateral heterogeneity observed in a laterally mobile immiscible mixed polyelectrolyte-neutral polymer brush.

Authors:  Hoyoung Lee; Vasilios Tsouris; Yunho Lim; Rafid Mustafa; Je Choi; Yun Hwa Choi; Hae-Woong Park; Mati Meron; Binhua Lin; You-Yeon Won
Journal:  Soft Matter       Date:  2014-04-03       Impact factor: 3.679

8.  Structure and elasticity of bush and brush-like models of the endothelial glycocalyx.

Authors:  Aleksei Kabedev; Vladimir Lobaskin
Journal:  Sci Rep       Date:  2018-01-10       Impact factor: 4.379

9.  Polymerization and Structure of Opposing Polymer Brushes Studied by Computer Simulations.

Authors:  Krzysztof Halagan; Michal Banaszak; Jaroslaw Jung; Piotr Polanowski; Andrzej Sikorski
Journal:  Polymers (Basel)       Date:  2021-12-08       Impact factor: 4.329

10.  Triblock copolymer micelle model of spherical paraspeckles.

Authors:  Tetsuya Yamamoto; Tomohiro Yamazaki; Tetsuro Hirose
Journal:  Front Mol Biosci       Date:  2022-08-22
  10 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.