Monitoring of pulmonary arterial diastolic pressure through a right ventricular pressure transducer.

Pulmonary arterial diastolic pressure is an important parameter for hemodynamic monitoring in congestive heart failure. It is traditionally obtained through a pulmonary arterial catheter. If it could be obtained from a sensor in the right ventricle, chronic monitoring would be possible without the use of a pulmonary arterial catheter. This study is based on the hypothesis that pulmonary valve opening and pulmonary arterial diastolic pressure occur at the time of maximum positive rate of pressure development (dP/dt) in the right ventricle, when the pressures should be equal. Thus, right ventricular pressure at the time of maximum dP/dt (PAD index) should be a reasonable estimate of pulmonary arterial diastolic pressure. Eight patients with heart failure were catheterized and exposed to hemodynamic stress. Right ventricular and pulmonary arterial pressures were simultaneously recorded from a Millar (Houston, TX) catheter with two pressure transducers. The distal transducer was positioned in the bifurcation of the pulmonary artery and the proximal transducer was placed in the right ventricle. Pulmonary arterial diastolic pressure and PAD index were stored beat by beat on a bed-side computer. Acceptable recordings were obtained in all patients. Recordings from the individual patients showed a good covariation between PAD index and pulmonary arterial pressure during different hemodynamic manuevers, except during infusion of dobutamine, when the correlation was not as good. Pulmonary arterial diastolic pressure may be estimated from a transducer in the right ventricle, thus eliminating the need for a permanent pulmonary arterial catheter in an implantable hemodynamic monitoring system. Further studies are needed to verify the correlation on a long-term basis.