BACKGROUND AND PURPOSE: Although mice, rats, and other small animals are commonly used for molecular biology research, their use in the evaluation of cerebral vasospasm after subarachnoid hemorrhage is somewhat problematic because of the correspondingly small size of their cerebral vessels. We have already reported that the corrosion cast technique was useful for evaluating newly formed cerebral vessels in neural grafts in these small animals. In the present study we applied the corrosion cast technique to the evaluation of hemolysate-induced cerebral vasospasm in rats and performed three-dimensional analysis for comparison. The casting was done 10 minutes after the hemolysate injection, so that only acute "vasospasm" was assessed. METHODS: After withdrawal of 0.1 mL cerebrospinal fluid, 0.2 mL hemolysate (n = 9) or saline (n = 10) was injected into the cisterna magna of male Sprague-Dawley rats weighing between 300 and 350 g. Ten minutes later, perfusion of a semipolymerized casting medium was performed at an injection pressure of 100 to 120 mm Hg. The brains were immersed and corroded in 10% NaOH solution. After these procedures, the basilar artery as well as peripheral vessels was analyzed morphologically with scanning electron microscopy. Conventional histological analysis with the use of paraffin-embedded section with hematoxylin-eosin staining was also performed, and the results were compared with those for the corrosion cast methods. RESULTS: In the saline-injected group, SEM showed that the inner surface of the basilar artery was smooth and the form of the endothelial cell was printed on the surface of the cast. In the hemolysate-injected group, the basilar artery showed an apparent vasospasm over its entire length, and corrugation was observed on the inner surface of the basilar artery in a three-dimensional fashion. Higher magnification revealed that the nuclei of the endothelial cells were distorted. Local narrowing of the basilar artery and vasospasm in the arteries of the anterior circulation and in peripheral arteries were also observed. Measurement of the inner diameter of the basilar artery showed 37.8% contraction in the hemolysate-injected group compared with the saline-injected group by the corrosion cast method. This degree of vasospasm was similar to that observed by the conventional histological method. CONCLUSIONS: In this report we show that detailed three-dimensional observation in the rat can be performed qualitatively and quantitatively with the corrosion cast technique. We conclude that this method derives an accurate measurement of the diameter of rat major cerebral arteries and is more reliable for analyzing vasospasm in rats than angiography and other conventional procedures.
BACKGROUND AND PURPOSE: Although mice, rats, and other small animals are commonly used for molecular biology research, their use in the evaluation of cerebral vasospasm after subarachnoid hemorrhage is somewhat problematic because of the correspondingly small size of their cerebral vessels. We have already reported that the corrosion cast technique was useful for evaluating newly formed cerebral vessels in neural grafts in these small animals. In the present study we applied the corrosion cast technique to the evaluation of hemolysate-induced cerebral vasospasm in rats and performed three-dimensional analysis for comparison. The casting was done 10 minutes after the hemolysate injection, so that only acute "vasospasm" was assessed. METHODS: After withdrawal of 0.1 mL cerebrospinal fluid, 0.2 mL hemolysate (n = 9) or saline (n = 10) was injected into the cisterna magna of male Sprague-Dawley rats weighing between 300 and 350 g. Ten minutes later, perfusion of a semipolymerized casting medium was performed at an injection pressure of 100 to 120 mm Hg. The brains were immersed and corroded in 10% NaOH solution. After these procedures, the basilar artery as well as peripheral vessels was analyzed morphologically with scanning electron microscopy. Conventional histological analysis with the use of paraffin-embedded section with hematoxylin-eosin staining was also performed, and the results were compared with those for the corrosion cast methods. RESULTS: In the saline-injected group, SEM showed that the inner surface of the basilar artery was smooth and the form of the endothelial cell was printed on the surface of the cast. In the hemolysate-injected group, the basilar artery showed an apparent vasospasm over its entire length, and corrugation was observed on the inner surface of the basilar artery in a three-dimensional fashion. Higher magnification revealed that the nuclei of the endothelial cells were distorted. Local narrowing of the basilar artery and vasospasm in the arteries of the anterior circulation and in peripheral arteries were also observed. Measurement of the inner diameter of the basilar artery showed 37.8% contraction in the hemolysate-injected group compared with the saline-injected group by the corrosion cast method. This degree of vasospasm was similar to that observed by the conventional histological method. CONCLUSIONS: In this report we show that detailed three-dimensional observation in the rat can be performed qualitatively and quantitatively with the corrosion cast technique. We conclude that this method derives an accurate measurement of the diameter of rat major cerebral arteries and is more reliable for analyzing vasospasm in rats than angiography and other conventional procedures.
Authors: Lukas H Kus; Michael C Sklar; Jaina Negandhi; Marvin Estrada; Antoine Eskander; Robert V Harrison; Paolo Campisi; Vito Forte; Evan J Propst Journal: J Otolaryngol Head Neck Surg Date: 2013-10-14
Authors: Daniel Hänggi; Jason Perrin; Sven Eicker; Kerim Beseoglu; Nima Etminan; Marcel Alexander Kamp; Hi-Jae Heiroth; Nadia Bege; Stephan Macht; Katrin Frauenknecht; Clemens Sommer; Thomas Kissel; Hans-Jakob Steiger Journal: PLoS One Date: 2012-09-25 Impact factor: 3.240