Evaluation of a series of tyrosine-derived polycarbonates as degradable biomaterials.

A series of four polycarbonates derived from the ethyl, butyl, hexyl, and octyl esters of desaminotyrosyl-tyrosine was prepared by condensation polymerization. The resulting polymers had weight average molecular weights ranging from 120,000-450,000, and their chemical structure was confirmed by elemental analysis, nuclear magnetic resonance, and Fourier transform infrared spectroscopy. The polycarbonates were evaluated as degradable biomaterials. Their surface properties were determined by electron spectroscopy for chemical analysis, attenuated total reflectance-Fourier transformed infrared spectroscopy, and contact angle measurement. The degree of surface hydrophobicity was related to the length of the alkyl ester pendent chain. The tensile properties were dependent on the chemical structure of the polymers: For thin, solvent cast film specimens, the tensile modulus varied from 1.2-1.6 GPa, and the strength at break from 60-220 MPa. The degradation of polymeric films was followed in vitro by measuring changes in mechanical strength for up to 40 weeks, and the decrease in molecular weight and changes in surface chemistry for up to 80 weeks. The length of the pendent chain affected the degradation behavior and strength retention; the polymers with short pendent chains were more readily hydrolyzable. For sterilization, ethylene oxide treatment was less destructive, as judged by molecular weight retention, than gamma-irradiation. Spin-cast films of all tested polycarbonates were not cytotoxic toward cultured rat lung fibroblasts. The cell response was influenced by the chemical structure of the polymer. The least hydrophobic polycarbonate (having a short ethyl ester pendent chain) was a more stimulating substrate for cell growth than the more hydrophobic polymers (carrying longer alkyl ester pendent chains).