Muscle length alters geometry of arterioles and venules in hamster retractor.

We investigated how changes in muscle length (Lm) would alter the geometry of arterioles and venules and whether such an effect would depend on the orientation of microvessels to muscle fibers. The parallel-fibered retractor muscle of anesthetized (pentobarbital sodium, 65 mg/kg) male hamsters (n = 20, 105 +/- 4 g) was exposed and irrigated with physiological saline solution (pH 7.4; 35 degrees C). Sarcomere length (Ls) was measured at x2,400 magnification after topical application (3 min, 10(-5) M) of a fluorescent dye [4-(4-diethylaminostyryl)-N-methylpyridinium iodide]. In vivo Ls at resting Lm (i.e., at Lm = 100%) was 3.00 +/- 0.02 microns. The origin and insertion of the retractor were cut, and the muscle was reflected dorsally while the circulation arising from the ventral surface was preserved. Polystyrene "tendons" were glued to each end of the muscle to control Lm, which was varied in 10% increments from 80 to 130% of in situ Lm; Ls increased linearly (r2 = 0.82) from 2.58 +/- 0.03 to 3.89 +/- 0.07 microns, respectively. Arteriole and venule branches and the centerline of "Y" bifurcations were classified based on orientation angles (theta) with respect to muscle fibers at Lm = 100%; three categories were defined using trigonometry (detailed in the APPENDIX) based on microvessel behavior during changes in Lm: parallel (P), 0 degree < or = theta < or = 32.6 degrees; intermediate (I), 32.6 degrees < theta < 59.4 degrees; and normal (N), 59.4 degrees < or = theta < or = 90 degrees.(ABSTRACT TRUNCATED AT 250 WORDS)