Ceramic inlay movement during polymerization of resin luting cements.

In cavities with no support for inlays, polymerization contraction of the resin cement may move the ceramic inlay axially. The purpose of this study was to determine the velocity and extent of such movement. Cylindrical ceramic inlays were placed in dentin cavities filled with one of four commercially available resin composite cements. An initial standardized 200-microns-thick cement film was created. The movement of the ceramic inlay during polymerization of one of the resin cements was measured by a dial gauge. The velocity of the inlay movement decreased exponentially with time and with a velocity constant of 0.09 min-1. The majority of the movement occurred within the first 12 min after photopolymerization and probably continued for several days, reaching an estimated value of 5.8 microns. After 1-2 d of water storage, 1-2-microns contraction gaps at the cavity floors were observed microscopically for every cement used. It is concluded that in cavities without support for the inlay, about 2/3 of the resin cement contraction results in movement of the inlay and about 1/3 results in formation of gaps at the cavity floors.