Destabilization of phosphatidylethanolamine liposomes at the hexagonal phase transition temperature.

We have examined whether there is a relationship between the lamellar-hexagonal phase transition temperature, TH, and the initial kinetics of H+- and Ca2+-induced destabilization of phosphatidylethanolamine (PE) liposomes. The liposomes were composed of dioleoylphosphatidylethanolamine, egg phosphatidylethanolamine (EPE), or phosphatidylethanolamine prepared from egg phosphatidylcholine by transesterification (TPE). These lipids have well-spaced lamellar-hexagonal phase transition temperatures (approximately 12, approximately 45, and approximately 57 degrees C) in a temperature range that allows us to measure the initial kinetics of bilayer destabilization, both below and above TH. The liposomes were prepared at pH 9.5. The TH of EPE and TPE was measured by using differential scanning calorimetry, and it was found that the TH was essentially the same at low pH or at high pH in the presence of 20 mM Ca2+. At temperatures well below TH, either at pH 4.5 or at pH 9.5 in the presence of Ca2+, the liposomes aggregate, leak, and undergo lipid mixing and mixing of contents. We show that liposome/liposome contact is involved in the destabilization of the PE liposomes. The temperature dependence of leakage, lipid mixing, and mixing of contents shows that there is a massive enhancement in the rate of leakage when the temperature approaches the TH of the particular PE and that lipid mixing appears to be enhanced. However, the fusion (mixing of aqueous contents) is diminished or even abolished at temperatures above TH. At and above the TH, a new mechanism of liposome destabilization arises, evidently dependent upon the ability of the PE molecules to adapt new morphological structures at these temperatures. We propose that this destabilization demarks the first step in the pathway to the eventual formation of the HII phase. Thus, the polymorphism accessible to PE is a powerful agent for membrane destabilization, but additional factors are required for fusion.