Shotaro Araki1, Takafumi Hiranaka2, Kenjiro Okimura1, Takaaki Fujishiro1, Koji Okamoto1. 1. Department of Orthopaedic Surgery and Joint Surgery Centre, Takatsuki General Hospital, 1-3-13, Kosobe-cho, Takatsuki, Osaka, 569-1192, Japan. 2. Department of Orthopaedic Surgery and Joint Surgery Centre, Takatsuki General Hospital, 1-3-13, Kosobe-cho, Takatsuki, Osaka, 569-1192, Japan. takafumi.hiranaka@gmail.com.
Abstract
INTRODUCTION: In Oxford unicompartmental knee arthroplasty (OUKA), the flexion and extension gaps should be adjusted to prevent mobile-bearing dislocation. The extension gap is recommended to be evaluated in the 20° flexion position to avoid underestimation due to tension of the posterior capsule. However, we have become aware of a looser gap in full extension than in 20° flexion in some instances. MATERIALS AND METHODS: We retrospectively investigated 83 knees in 60 patients who underwent OUKA between January and June 2020. During surgery, the extension gaps were measured in both full extension and 20° flexion. The knees were classified into two groups: the gap was looser in full extension (0° group), and the gap was equal or looser in 20° flexion than in full extension (20° group). The hip-knee-ankle angle (HKAA), the lateral distal femoral angle (LDFA), the medial proximal tibia angle (MPTA), the posterior tibial slope angle (PTSA), and the last spigot size were also measured and compared between the groups. RESULTS: There was looseness in approximately 41% of knees (34 out of 83 knees) in full extension. In the knees in the 0° group, the last spigot size was significantly smaller (median 1 and 2, P < 0.01). However, there were no significant differences in the HKAA, MPTA, LDFA or PTSA between the groups. CONCLUSIONS: Approximately 41% of knees have a looser gap in full extension than in 20° flexion after OUKA. Further investigation is needed to better understand which extension gap should be used in such cases, and to find the contributing factors in loose full extension gap other than the size of the last spigot.
INTRODUCTION: In Oxford unicompartmental knee arthroplasty (OUKA), the flexion and extension gaps should be adjusted to prevent mobile-bearing dislocation. The extension gap is recommended to be evaluated in the 20° flexion position to avoid underestimation due to tension of the posterior capsule. However, we have become aware of a looser gap in full extension than in 20° flexion in some instances. MATERIALS AND METHODS: We retrospectively investigated 83 knees in 60 patients who underwent OUKA between January and June 2020. During surgery, the extension gaps were measured in both full extension and 20° flexion. The knees were classified into two groups: the gap was looser in full extension (0° group), and the gap was equal or looser in 20° flexion than in full extension (20° group). The hip-knee-ankle angle (HKAA), the lateral distal femoral angle (LDFA), the medial proximal tibia angle (MPTA), the posterior tibial slope angle (PTSA), and the last spigot size were also measured and compared between the groups. RESULTS: There was looseness in approximately 41% of knees (34 out of 83 knees) in full extension. In the knees in the 0° group, the last spigot size was significantly smaller (median 1 and 2, P < 0.01). However, there were no significant differences in the HKAA, MPTA, LDFA or PTSA between the groups. CONCLUSIONS: Approximately 41% of knees have a looser gap in full extension than in 20° flexion after OUKA. Further investigation is needed to better understand which extension gap should be used in such cases, and to find the contributing factors in loose full extension gap other than the size of the last spigot.
Authors: Ignace Ghijselings; Orcun Taylan; Hendrik Pieter Delport; Josh Slane; Hans Van den Wyngaert; Alex Demurie; Lennart Scheys Journal: Arch Orthop Trauma Surg Date: 2021-07-03 Impact factor: 3.067