Production and storage stability of concentrated micellar casein.

Concentrated micellar casein (CMC) is a high-protein ingredient that can be used in process cheese product formulations. The objectives of this study were to develop a process to produce CMC and to evaluate the effect of sodium chloride and sodium citrate on its storage stability. Skim milk was pasteurized at 76°C for 16 s and cooled to ≤4°C. The skim milk was heated to 50°C using a plate heat exchanger and microfiltered with a graded permeability (GP) ceramic microfiltration (MF) membrane system (0.1 μm) in a continuous feed-and-bleed mode (flux of 71.43 L/m2 per hour) using a 3× concentration factor (CF) to produce a 3× MF retentate. Subsequently, the retentate of the first stage was diluted 2× with soft water (2 kg of water: 1 kg of retentate) and again MF at 50°C using a 3× CF. The retentate of the second stage was then cooled to 4°C and stored overnight. The following day, the retentate was heated to 63°C and MF in a recirculation mode until the total solids (TS) reached approximately 22% (wt/wt). Subsequently, the MF system temperature was increased to 74°C and MF until the permeate flux was <3 L/m2 per hour. The CMC was then divided into 3 aliquots (approximately 10 kg each) at 74°C. The first portion was a control, whereas 1% of sodium chloride was added to the second portion (T1), and 1% of sodium chloride plus 1% of sodium citrate were added to the third portion (T2). The CMC retentates were transferred hot to sterilized vials and stored at 4°C. This trial was repeated 3 times using separate lots of skim milk. The CMC at d 0 (immediately after manufacturing) contained 25.41% TS, 21.65% true protein (TP), 0.09% nonprotein nitrogen (NPN), and 0.55% noncasein nitrogen (NCN). Mean total aerobic bacterial counts (TBC) in control, T1, and T2 at d 0 were 2.6, 2.5, and 2.8 log cfu/mL, respectively. The level of proteolysis (NCN and NPN values) increased with increasing TBC during 60 d of storage at 4°C. This study determined that CMC with >25% TS and >95% casein as percentage of TP can be manufactured using GP MF ceramic membranes and could be stored up to 60 d at 4°C. The effects of the small increase in NCN and NPN, as well as the addition of sodium chloride or sodium citrate in CMC during 60 d of storage on process cheese characteristics, will be evaluated in subsequent studies. The Authors. Published by Elsevier Inc. and Fass Inc. on behalf of the American Dairy Science Association®. This is an open access article under the CC BY license (http://creativecommons.org/licenses/by/4.0/).