Personalized, 3D- printed fracture fixation plates versus commonly used orthopedic implant materials- biomaterials characteristics and bacterial biofilm formation.

Additive manufacturing enabled the development of personalized, ideally fitting medical devices. The topography of the surface of the 3D-printed implant may not only facilitate its integration but also cause its rejection, as the surface may become a reservoir for different bacterial strains. In this study, the innovative, raw, 3D- printed fracture fixation plates, manufactured by using selective laser melting (SLM) from Ti-6Al-4V were compared with commercially available, surface-modified plates commonly used in orthopedic surgery. The topography surface of the plates was studied by atomic force microscopy. Susceptibility to the development of biofilm was tested for Staphylococcus epidermidis, Staphylococcus aureus and Streptococcus mutans by using crystal violet staining of biomass, confocal, and scanning electron microscopy (SEM). 3D- printed plates showed higher roughness (Sa=131.0 nm) than commercial plates (CP1 and CP2), Sa= 60.67 nm and Sa=55.48 nm, respectively. All strains of bacteria colonized 3D- printed raw plates more densely than commercial plates. The microscopic visualization showed biofilm mostly in irregular cavities of printed plates while on commercial plates it was mainly located along the edges. The research has indicated that there is need for further development of this technology to optimize its effectiveness and safety.