Microfluidic Chip Device for In Situ Mixing and Fabrication of Hydrogel Microspheres via Michael-Type Addition.

Hydrogel microspheres are sought for a variety of biomedical applications, including therapeutic and cellular delivery, sensors, and lubricants. Robust fabrication of hydrogel microspheres with uniform sizes and properties can be achieved using microfluidic systems that rely on droplet formation and subsequent gelation to form microspheres. Such systems work well when gelation is initiated after droplet formation but are not practical for timed gelation systems where gelation is initiated prior to droplet formation; premature gelation can lead to device blockage, variable microsphere diameter due to viscosity changes in the precursor solution, and limited numbers of microspheres produced in a single run. To enable microfluidic fabrication of microspheres from timed gelation hydrogel systems, an in situ mixing region is needed so that various hydrogel precursor components can be added separately. Here, we designed and evaluated three mixing devices for their effectiveness at mixing hydrogel precursor solutions prior to droplet formation and subsequent gelation. The serpentine geometry was found to be the most effective and was further improved with the inclusion of a pillar array to increase agitation. The optimized device was shown to fully mix precursor solutions and enable the fabrication of monodisperse polyethylene glycol microspheres, offering great potential for use with timed gelation hydrogel systems.