Exsolution of Ni Nanoparticles from A-Site-Deficient Layered Double Perovskites for Dry Reforming of Methane and as an Anode Material for a Solid Oxide Fuel Cell.

Exsolution is a promising technique to design metal nanoparticles for electrocatalysis and renewable energy. In this work, Ni-doped perovskites, (Pr0.5Ba0.5)1-x/2Mn1-x/2Nix/2O3-δ with x = 0, 0.05, 0.1, and 0.2 (S-PBMNx), were prepared to design exsolution systems as solid oxide fuel cell anodes and for catalysis applications. X-ray diffraction and transmission electron microscopy (TEM) analyses demonstrated that correlating A-site deficiency with Ni content can effectively induce exsolution of all Ni under H2 atmosphere at T ∼ 875 °C, yielding the reduced (exsolved) R-PBMNx materials. On heating the exsolution systems in air, metal incorporation in the oxide lattice did not occur; instead, the Ni nanoparticles oxidized to NiO on the layered perovskite surface. The lowest area-specific resistance (ASR) under wet 5% H2/N2 in symmetrical cells was observed for R-PBMN0.2 anode (ASR ∼ 0.64 Ω cm2 at 850 °C) due to the highest Ni particle density in the R-PBMNx series. The best performance for dry reforming of methane (DRM) was also obtained for R-PBMN0.2, with CH4 and CO2 conversion rates at 11 and 32%, respectively, and the highest production of H2 (37%). The DRM activity of R-PBMN0.2 starts at 800 °C and is sustained for up to at least 5 h operation with little carbon deposition (0.017 g·gcat-1·h-1). These results clearly demonstrate that varying Ni-doping in layered double perovskite oxides is an effective strategy to manipulate the electrochemical performance and catalytic activity for energy conversion purposes.