PURPOSE: To assess the influence of liquid attached on the tooth surfaces on the accuracy (trueness and precision) of intraoral scanners and the effectiveness of the drying method (using compression air) to exclude the influence of liquid on the scanning results. MATERIALS AND METHODS: A mandibular jaw model was scanned using an industrial computed tomography scanner to obtain a reference model. A scanning platform was designed to simulate three specific tooth surface states (dry, wet, blow-dry). Two kinds of liquids (ultra-pure water and artificial saliva) were used for the test. Two intraoral scanners (Trios 3 and Primescan) were used to scan the mandibular jaw model 10 times under each condition. All scanning data were processed and analyzed using dedicated software (Geomagic Control 2015). Trueness and precision comparison were conducted within the 12 groups of 3D models divided based on different intraoral scanners and liquids used under each condition. The root mean square (RMS) value was used to indicate the difference between the aligned virtual models. The color maps were used to evaluate and observe the deviation distribution patterns. The 3-way ANOVA (condition, intraoral scanner, liquid) followed by the Tukey test were used to assess precision and trueness. The level of significance was set at 0.05. RESULTS: The mean RMS values obtained from wet condition were significantly higher than those of the dry and blow-dry condition (p < 0.001, F = 64.033 for trueness and F = 54.866 for precision), which indicates less accurate trueness and precision for wet condition. For two different types of liquids, the mean RMS value was not significantly different on trueness and precision. The deviations caused by liquid were positive and mainly distributed in the pits and fissures of the occlusal surface of posterior teeth, the interproximal area of the teeth, and the margin of the abutments. CONCLUSIONS: Liquid on the tooth surface could affect intraoral scanning accuracy. Blow-drying with a three-way syringe can reduce scanning errors.
PURPOSE: To assess the influence of liquid attached on the tooth surfaces on the accuracy (trueness and precision) of intraoral scanners and the effectiveness of the drying method (using compression air) to exclude the influence of liquid on the scanning results. MATERIALS AND METHODS: A mandibular jaw model was scanned using an industrial computed tomography scanner to obtain a reference model. A scanning platform was designed to simulate three specific tooth surface states (dry, wet, blow-dry). Two kinds of liquids (ultra-pure water and artificial saliva) were used for the test. Two intraoral scanners (Trios 3 and Primescan) were used to scan the mandibular jaw model 10 times under each condition. All scanning data were processed and analyzed using dedicated software (Geomagic Control 2015). Trueness and precision comparison were conducted within the 12 groups of 3D models divided based on different intraoral scanners and liquids used under each condition. The root mean square (RMS) value was used to indicate the difference between the aligned virtual models. The color maps were used to evaluate and observe the deviation distribution patterns. The 3-way ANOVA (condition, intraoral scanner, liquid) followed by the Tukey test were used to assess precision and trueness. The level of significance was set at 0.05. RESULTS: The mean RMS values obtained from wet condition were significantly higher than those of the dry and blow-dry condition (p < 0.001, F = 64.033 for trueness and F = 54.866 for precision), which indicates less accurate trueness and precision for wet condition. For two different types of liquids, the mean RMS value was not significantly different on trueness and precision. The deviations caused by liquid were positive and mainly distributed in the pits and fissures of the occlusal surface of posterior teeth, the interproximal area of the teeth, and the margin of the abutments. CONCLUSIONS: Liquid on the tooth surface could affect intraoral scanning accuracy. Blow-drying with a three-way syringe can reduce scanning errors.