Georgios Kanavakis1, Simeon T Häner2, François Matthey3, Nikolaos Gkantidis2. 1. Department of Pediatric Oral Health and Orthodontics, University Center for Dental Medicine, University of Basel, Basel, Switzerland; Department of Orthodontics, Tufts University School of Dental Medicine, Boston, Mass. Electronic address: georgios.kanavakis@unibas.ch. 2. Department of Orthodontics and Dentofacial Orthopedics, University of Bern, Bern, Switzerland. 3. Private practice, Neuchâtel, Switzerland.
Abstract
INTRODUCTION: The aim of this investigation was to evaluate the reproducibility of a voxel-based 3-dimensional superimposition method and the effect of segmentation error on determining soft tissue surface changes. METHODS: A total of 15 pairs of serial cone-beam computed tomography images (interval: 1.69 ± 0.37 years) from growing subjects (initial age: 11.75 ± 0.59 years) were selected from an existing digital database. Each pair was superimposed on the anterior cranial base, in 3 dimensions with Dolphin 3D software (version 2.1.6079.17633; Dolphin Imaging & Management Solutions, Chatsworth, Calif). The reproducibility of superimposition outcomes and surface segmentation were tested with intra- and interoperator comparisons. RESULTS: Median differences in inter- and intrarater measurements at various areas presented a range of 0.08-0.21 mm. In few instances, the differences were larger than 0.5 mm. In areas where T0-T1 changes were increased, the error did not appear to increase. However, the method error increased the farther the measurement area was from the superimposition reference structure. For individual images, the median soft tissue segmentation error ranged from 0.05 to 0.06 at various areas and in no subject exceeded 0.13 mm. CONCLUSIONS: The presented voxel-based superimposition method was efficient and well reproducible. The segmentation process was a minimal source of error; however, there were a few cases in which the total error was more than 0.5 mm and could be considered clinically significant. Therefore, this method can be used clinically to assess 3-dimensional soft tissue changes during orthodontic treatment in growing patients.
INTRODUCTION: The aim of this investigation was to evaluate the reproducibility of a voxel-based 3-dimensional superimposition method and the effect of segmentation error on determining soft tissue surface changes. METHODS: A total of 15 pairs of serial cone-beam computed tomography images (interval: 1.69 ± 0.37 years) from growing subjects (initial age: 11.75 ± 0.59 years) were selected from an existing digital database. Each pair was superimposed on the anterior cranial base, in 3 dimensions with Dolphin 3D software (version 2.1.6079.17633; Dolphin Imaging & Management Solutions, Chatsworth, Calif). The reproducibility of superimposition outcomes and surface segmentation were tested with intra- and interoperator comparisons. RESULTS: Median differences in inter- and intrarater measurements at various areas presented a range of 0.08-0.21 mm. In few instances, the differences were larger than 0.5 mm. In areas where T0-T1 changes were increased, the error did not appear to increase. However, the method error increased the farther the measurement area was from the superimposition reference structure. For individual images, the median soft tissue segmentation error ranged from 0.05 to 0.06 at various areas and in no subject exceeded 0.13 mm. CONCLUSIONS: The presented voxel-based superimposition method was efficient and well reproducible. The segmentation process was a minimal source of error; however, there were a few cases in which the total error was more than 0.5 mm and could be considered clinically significant. Therefore, this method can be used clinically to assess 3-dimensional soft tissue changes during orthodontic treatment in growing patients.