Saeid Kamal1, Ata Hashemi1. 1. Biomechanical Engineering Group, Biomedical Engineering Department, Amirkabir University of Technology, Tehran, Iran.
Abstract
BACKGROUND: The vertebral column is the second most common fracture site in individuals with high-grade osteoporosis (30-50%). Most of these fractures are caused by falls. This information reveals the importance of considering impact loading conditions of spinal motion segments, while no commercial apparatus is available for this purpose. Therefore, the goal was set to fabricate an impact testing device for the measurement of impact behavior of the biological tissues. METHODS: In the present study, first, a drop-weight impact testing apparatus was designed and fabricated to record both force and displacement at a sample rate of 100 kHz. A load cell was placed under the sample, and an accelerometer was located on the impactor. Previous devices have mostly measured the force and not the deformation. Thereafter, the effect of high axial compression load was investigated on a biological sample, i.e., the lumbar motion segment, was investigated. To this end, nine ovine segments subjected to vertical impact load were examined using the fabricated device, and the mechanical properties of the lumbar segments were extracted and later compared with quasi-static loading results. RESULTS: The results indicated that the specimen stiffness and failure energy in impact loading were higher than those in the quasi-static loading. In terms of the damage site, fracture mainly occurred in the body of the vertebra during impact loading; although, during quasi-static loading, the fracture took place in the endplates. CONCLUSION: The present study introduces an inexpensive drop-test device capable of recording both the force and the deformation of the biological specimens when subjected to high-speed impacts. The mechanical properties of the spinal segments have also been extracted and compared with quasi-static loading results.
BACKGROUND: The vertebral column is the second most common fracture site in individuals with high-grade osteoporosis (30-50%). Most of these fractures are caused by falls. This information reveals the importance of considering impact loading conditions of spinal motion segments, while no commercial apparatus is available for this purpose. Therefore, the goal was set to fabricate an impact testing device for the measurement of impact behavior of the biological tissues. METHODS: In the present study, first, a drop-weight impact testing apparatus was designed and fabricated to record both force and displacement at a sample rate of 100 kHz. A load cell was placed under the sample, and an accelerometer was located on the impactor. Previous devices have mostly measured the force and not the deformation. Thereafter, the effect of high axial compression load was investigated on a biological sample, i.e., the lumbar motion segment, was investigated. To this end, nine ovine segments subjected to vertical impact load were examined using the fabricated device, and the mechanical properties of the lumbar segments were extracted and later compared with quasi-static loading results. RESULTS: The results indicated that the specimen stiffness and failure energy in impact loading were higher than those in the quasi-static loading. In terms of the damage site, fracture mainly occurred in the body of the vertebra during impact loading; although, during quasi-static loading, the fracture took place in the endplates. CONCLUSION: The present study introduces an inexpensive drop-test device capable of recording both the force and the deformation of the biological specimens when subjected to high-speed impacts. The mechanical properties of the spinal segments have also been extracted and compared with quasi-static loading results.