Viable virus aerosol propagation by positive airway pressure (PAP) circuit leak and mitigation with a ventilated patient hood.

INTRODUCTION: Nosocomial transmission of SARS-CoV-2 has been a major feature of the COVID-19 pandemic. Evidence suggests patients can auto-emit aerosols containing viable viruses, these aerosols could be further propagated when patients undergo certain treatments including continuous positive airway pressure (PAP) therapy. Our aim was to assess i) the degree of viable virus propagated from PAP circuit mask leak, ii) the efficacy of a ventilated plastic canopy to mitigate virus propagation.
METHODS: Bacteriophage PhiX174 (108 copies·mL-1) was nebulised into a custom PAP circuit. Mask leak was systematically varied at the mask interface. Plates containing Escherichia coli host quantified viable virus (via plaque forming unit) settling on surfaces around the room. The efficacy of a low-cost ventilated headboard created from a tarpaulin hood and a high efficiency particulate air (HEPA) filter was tested.
RESULTS: Mask leak was associated with virus contamination in a dose-dependent manner (χ2=58.24, df=4, p<0.001). Moderate mask leak (≥21 L·min-1) was associated with virus counts equivalent to using PAP with a vented mask. The highest frequency of viruses was detected on surfaces 1 m away, however, viable viruses were recorded up to 3.86 m from the source. A plastic hood with HEPA filtration significantly reduced viable viruses on all plates. HEPA exchange rates ≥170 m3·hr-1 eradicated all evidence of virus contamination.
CONCLUSION: Mask leak from PAP may be a major source of environmental contamination and nosocomial spread of infectious respiratory diseases. Subclinical mask leak levels should be treated as an infectious risk. Low-cost patient hoods with HEPA filtration are an effective countermeasure.