| Literature DB >> 32982964 |
Jakob Albrethsen1,2, Anders Juul1,2, Anna-Maria Andersson1,2.
Abstract
The structure of the testicular peptide hormone insulin-like factor 3 (INSL3) has been the subject of discussion for more than a decade. Some studies support that the central C-domain of INSL3 is proteolytically removed and that INSL3 is secreted by the testicular Leydig cells into circulation as a small heterodimer consisting of an A- and a B-chain linked by two disulfide bridges. Other studies support that the INSL3 peptide remains uncleaved and that the predominant structure of circulating INSL3 is the larger pro-form. Furthermore, the structure of INSL3 could differ between species, and both structural forms of INSL3 could, in principle, be present in circulation. Recently, we have developed a mass spectrometry (MS)-based method for INSL3 in human serum that provides new information about the structure of circulating INSL3. Based on recent and newly presented data, we argue that in healthy men, the common, and probably the only, form of circulating INSL3 is the smaller AB heterodimer. For the first time, we demonstrate that the same analytical principle, with slight modifications, can also be applied to sera from other species, and we show that the INSL3 AB heterodimer is also present in serum from rodents. Improved understanding of the structure and biochemistry of circulating INSL3 could be valuable for the interpretation of INSL3 as a marker for reproductive and developmental disorders in humans and domesticated animals.Entities:
Keywords: INSL3; LC-MS/MS; insulin family; peptide hormone; structure
Mesh:
Substances:
Year: 2020 PMID: 32982964 PMCID: PMC7484738 DOI: 10.3389/fendo.2020.00552
Source DB: PubMed Journal: Front Endocrinol (Lausanne) ISSN: 1664-2392 Impact factor: 5.555
Figure 1Maturation of the peptide hormone insulin-like factor 3 (INSL3). The black and gray boxes represent the four domains of the INSL3 peptide, including the signal peptide (black), B-chain (dark gray), C-domain (medium gray), and A-chain (light gray). The black lines represent the two disulfide bridges that connect the A- and B-chains, as well as the single internal disulfide bridge of the A-chain. During peptide maturation, the N-terminal signal peptide is first cleaved off from the “pre-pro-form.” This leaves the fully active “pro-form” consisting of the B-, C-, and A-chains. This form can undergo further proteolytic processing to produce the “insulin-like-form” where the central C-domain is cleaved out resulting in a heterodimer consisting of the A- and B-chains linked only by two disulfide bridges. Two forms have been identified in humans (gray boxes); isoform 5 has been identified in human plasma, and isoform 2 has been identified in human testicular tissues, whereas isoforms 3 and 4 represent hypothetical isoforms. Isoform 1 is presumed to be the original precursor peptide. The immunoassays would likely detect all shown possible human forms, whereas the MS-based assay would only detect human isoforms 3 and 5.
Figure 2Parallel LC-MS/MS-based measurement of human, rat, and mouse INSL3. The top table shows the three amino acid sequences (blue) of the INSL3 A-chains from human, rat, and mouse and the sequences (red) of the corresponding stable-isotope-labeled (SIL) synthetic peptides used as internal standards (IS). The heavily labeled residues (R and P) of the SIL peptides are enclosed in brackets. The underscored sequence shows the fragment/quantifier ion for LC-MS/MS analysis. The molecular weight (MW) after alkylation and the mass-to-charge ratio (m/z) of the precursor (Q1) and fragment ion (Q3) are shown for each peptide. The chromatograms below show LC-MS/MS analysis of water, male human serum, male rat serum, and male mouse serum, respectively. The red chromatograms are the retention time (RT) three IS peptides (spiked into all samples), and the blue are the endogenous INSL3 peptides. Due to the analytical specificity with LC-MS/MS, the method can distinguish between INSL3 from the three species.