Literature DB >> 32939131

Evaluation of Lactose-Based Direct Tableting Agents' Compressibility Behavior Using a Compaction Simulator.

Yıldız Özalp1, Motunrayo M Onayo1, Nailla Jiwa1.   

Abstract

OBJECTIVES: A compaction simulator (CS) is a single-punch instrument that records data during the powder compaction process. The aim of the study was to determine the behavior of lactose-based direct tableting agents (DTAs) by CS. The data recorded were used to evaluate the flowability and compressibility of powders. The focus of the study was on comparing the compressibility of StarLac® [alpha lactose monohydrate (85%) and white maize starch (15%)] and FlowLac®100 (spray-dried alpha lactose monohydrate) in order to make tablets containing poorly flowable paracetamol.
MATERIALS AND METHODS: Two lactose-based DTAs were used. Physical characterization of these powders was done by measuring bulk, tapped, and true densities alongside scanning electron microscopy analysis. Flow properties were then calculated by the angle of repose, Hausner ratio, and Carr's compressibility index. Force, in-die thickness, and punch displacement data produced by the CS were captured during in-die compression. Compressibility was calculated using the Heckel equation.
RESULTS: The physical characterization test results showed no significant difference between the two DTAs. Hardness results revealed that tablet formulations containing FlowLac® had higher sensitivity to an increase in compression force in comparison with StarLac®. From the Heckel plots generated by the CS during the compression cycle, yield pressure (Py) values were calculated for FlowLac®100 and StarLac®. The Heckel parameter (Py) for FlowLac®100 and StarLac® was calculated as 87.5 MPa and 85.2 MPa, respectively, during the compaction cycle at 5 kN. These data indicated that both powders are compressible and have brittle behavior.
CONCLUSION: StarLac® is less brittle, which was shown by its lower sensitivity to compression force. Py values obtained from the Heckel equation described the plasticity of particles, which gives distinct information on the compressibility of both DTAs in real time during the compaction cycle. ©Copyright 2020 Turk J Pharm Sci, Published by Galenos Publishing House.

Entities:  

Keywords:  Compaction simulator; FlowLac®100; StarLac®; compressibility; tablet

Year:  2020        PMID: 32939131      PMCID: PMC7489345          DOI: 10.4274/tjps.galenos.2019.94840

Source DB:  PubMed          Journal:  Turk J Pharm Sci        ISSN: 1304-530X


  9 in total

1.  Investigation of a new mathematical model for compression of pharmaceutical powders.

Authors:  J M Sonnergaard
Journal:  Eur J Pharm Sci       Date:  2001-09       Impact factor: 4.384

2.  Effect of variation in compaction force on properties of six direct compression tablet formulations.

Authors:  K A Khan; C T Rhodes
Journal:  J Pharm Sci       Date:  1976-12       Impact factor: 3.534

3.  Evaluation of a new coprocessed compound based on lactose and maize starch for tablet formulation.

Authors:  Karsten Hauschild; Katharina M Picker-Freyer
Journal:  AAPS PharmSci       Date:  2004-05-26

4.  Effect of particle size and compression force on compaction behavior and derived mathematical parameters of compressibility.

Authors:  Sarsvatkumar Patel; Aditya Mohan Kaushal; Arvind Kumar Bansal
Journal:  Pharm Res       Date:  2006-10-25       Impact factor: 4.200

5.  A particle rearrangement index based on the Kawakita powder compression equation.

Authors:  J Nordström; I Klevan; G Alderborn
Journal:  J Pharm Sci       Date:  2009-03       Impact factor: 3.534

6.  On the physical interpretation of the initial bending of a Shapiro-Konopicky-Heckel compression profile.

Authors:  Ingvild Klevan; Josefina Nordström; Annette Bauer-Brandl; Göran Alderborn
Journal:  Eur J Pharm Biopharm       Date:  2008-10-07       Impact factor: 5.571

7.  Effect of particle size and speed of compaction on density changes in tablets of crystalline and spray-dried lactose.

Authors:  J T Fell; J M Newton
Journal:  J Pharm Sci       Date:  1971-12       Impact factor: 3.534

8.  The effect of punch velocity on the compaction of a variety of materials.

Authors:  R J Roberts; R C Rowe
Journal:  J Pharm Pharmacol       Date:  1985-06       Impact factor: 3.765

9.  A comparison between two powder compaction parameters of plasticity: the effective medium A parameter and the Heckel 1/K parameter.

Authors:  Foad Mahmoodi; Ingvild Klevan; Josefina Nordström; Göran Alderborn; Göran Frenning
Journal:  Int J Pharm       Date:  2013-06-26       Impact factor: 5.875

  9 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.