Application of two anaerobic membrane bioreactors with different pore size membranes for municipal wastewater treatment.

Pore size is one of the most important properties in the successful operation of membrane-based bioprocesses for the treatment of municipal wastewater. The characteristics of two anaerobic membrane bioreactors (AnMBRs), one with a hollow fiber membrane of 0.4 μm pore size (AnMBR1), and the other with a membrane of 0.05 μm pore size (AnMBR2) were investigated for the treatment of real municipal wastewater at room temperature (25 °C) under varied hydraulic retention times (HRTs). Process performance was evaluated in terms of organic removal efficiency, biogas production and membrane filtration behaviours during a long-term continuous operation. Both AnMBRs showed good organic removal performance with COD and BOD removal efficiencies of around 89% and 93%, respectively. High energy recovery potential was achieved, with the biogas yield ranging between 0.20 and 0.26 L-gas/g-CODrem and a methane content of approximately 75%. The differences in the membrane filtration behaviours in the two AnMBRs included different permeate flux and total filtration resistance (Rt). In the AnMBR with a 0.4 μm pore size membrane, an average Rt of 1.08 × 10^12 m-1 was obtained even when the permeate flux was a high 0.274 m/day, while a higher average Rt of 1.51 × 10^12 m-1 was observed in the AnMBR with 0.05 μm pore size membrane even when the flux was a low 0.148 m/day. The off-line membrane cleaning strategy used for AnMBR1 indicated that the membrane restoration efficiency was 90.2%.