| Literature DB >> 32616781 |
Leonor Rodrigues1,2, Tobias Sprafke3, Carine Bokatola Moyikola4, Bernard G Barthès5, Isabelle Bertrand5, Marion Comptour6,7, Stéphen Rostain8, Joseph Yoka4, Doyle McKey6.
Abstract
The functioning and productivity of pre-Columbian raised fields (Entities:
Year: 2020 PMID: 32616781 PMCID: PMC7331663 DOI: 10.1038/s41598-020-67467-8
Source DB: PubMed Journal: Sci Rep ISSN: 2045-2322 Impact factor: 4.379
Figure 1Study area and the four studied fields. (A) Study area in the cuvette centrale (CC) of the Congo Basin (satellite imagery from the ESRI ArcGIS base map). Inset map shows the location of the Congo Basin and CC in Africa; red-bordered orange dot (in both inset and main maps) indicates the city of Mossaka (built on sand pumped from the Congo River), green rectangle indicates location of RFs N1–N3 (1°12′59.48"S/ 16°46′56.27"E). Green dot indicates location of the abandoned field AF (1°13′30.52"S/ 16°47′15.71"E). (B) Fields N1-N3 shown from the air and (C–E) from the ground (satellite imagery from the ESRI ArcGIS base map). In (E), the white dashed line shows the approximate border of the field). Photos (1–20 August 2017), Leonor Rodrigues and Tobias Sprafke.
Figure 2Mode of construction of RFs in Mossaka. (A) Materials used to construct RFs, and sequence of placement. Lipu: earth clumps with rooted vegetation; puleke: topsoil with vegetation debris; tse: topsoil from the RFSA; bongo: grey clay (C horizon) (Ilustration made with Adobe Illustrator). (B) Area cleared of vegetation and topsoil (tse) next to field N2 (which was planted with manioc). Photo (1–20 August 2017), Leonor Rodrigues.
Figure 3Age and internal morphology of RFs N1–N3. Layers are labeled with numbers. Left panel for each field presents the main profile (X), right panel the two side profiles (Y and Z). Note: layer 1 in side profiles of RF N3 is missing. It was unintentionally removed during our observation and sampling campaign when the field was cleared of fallow vegetation before excavation of the trench. Photos (1–20 August 2017), Leonor Rodrigues and Tobias Sprafke. (Ilustrations made with Adobe Illustrator).
Figure 4Fertility over time. The three different phases in the cycle of cultivation represented by fields N1 (two weeks after addition of fresh biomass to rehabilitate a field that had been left fallow for at least 10 years), N2 (one year after rehabilitation, field age > 40 years), and N3 (fallow, since about 10 years). Some fields are not only left fallow, but abandoned (AF, abandoned at least 20 years ago). Peak of chemical fertility in the layers where crop roots are concentrated is reached some months to one year after rehabilitation for cultivation (“Fertility Window”). Fertility then declines, returning to values typical of nearby uncultivated soils during the fallow period and falling even lower with abandonment. Plots show downprofile colour (visualized by conversion of spectrophotometrically measured colour space values into the RGB colour space[39] and chemical analysis of the main profiles (X) of fields N1, N2, and N3. Dashed lines in the background are the mean values for each chemical parameter of the topsoil (Ah) samples taken at 10 cm depth from areas near each field in the RFSA. (Graphs were plotted with Grapher and arranged using Adobe Illustrator).
Figure 5Scans and photomicrographs [plain polarized light (PPL)] from thin sections of field N2 illustrating the alteration of RF soils by biota. (A) Thin section from 60 cm depth, a mixed organo-mineral layer with large bio-pores and root channels infilled with faunal excrements. (A1) Soil structure made from bacillo-cylindric faunal excrements. (A2) Soil pore filled with degraded faunal excrements. B: Thin section from 85 cm depth encompassing three distinct layers (organic-mineral-organic) with boundaries (dashed red lines) blurred by mixing. (B1) Earthworm excrements (ec). (B2) Channel built by termites/ants (tc) infilled with bacillo-cylindric faunal excrements, most probably produced by small annelids (Enchytraeidae) or mites. Thin sections were analyzed with a Leica DMLP 2000 microscope. For complete documentation of micromorphology, see SI.