Rosalia Leonardi1, Simone Muraglie1, Antonino Lo Giudice1,2, K S Aboulazm3, R Nucera2. 1. Department of Orthodontics, School of Dentistry, University of Catania, Italy. 2. Department of Biomedical and Dental Sciences and Morphofunctional Imaging, Section of Orthodontics, University of Messina, Italy. 3. Department of Orthodontics, School of Dentistry, Pharos University, Alexandria, Egypt.
Abstract
OBJECTIVES: To investigate mandibular morphology in adults affected by posterior unilateral crossbite (PUXB) and to evaluate the hemi mandibular volumes from the crossbite (CB) and non-CB sides of the same patients. METHODS: Thirty-eight cone beam computed tomography (CBCT) images were consecutively recruited and the Digital Imaging and Communications in Medicine (DICOM)-formatted scans were volume rendered into a surface three-dimensional (3D) mesh model and volumes to obtain the 3D model of the mandibular bone. To achieve the surface point-to-point analysis of the mandibular models, a reverse engineering software was used. The same procedure was performed for an age-matched control group (19 CBCT images). RESULTS: Total mandibular volume showed a difference of 2.46 cm3 between patients and controls, which was not statistically significant. A mean difference of 1.53 cm3 was found comparing the hemi mandibular volumes from the CB and non-CB sides of PUXB patients, this difference was statistically significant (P ≤ 0.01). Findings for the surface-to-surface deviation analysis, demonstrated a higher percentage of mismatch in patients PUXB, over 10% at 0.5 mm tolerance level. LIMITATIONS: Limitations are related to the intrinsic surfaces matching methodology, that make difficult to evaluate discrepancies among different mandibular anatomical units. CONCLUSION: Adult patients affected by PUXB show a greater mandibular structural asymmetry compared to controls because of a lower matching percentage obtained from the surface-to-surface matching technique. IMPLICATIONS: Treatment of adult patients affected by PUXB should take into consideration the possibility of a mild mandibular asymmetry mainly localized at the condyle and gonial angle levels.
OBJECTIVES: To investigate mandibular morphology in adults affected by posterior unilateral crossbite (PUXB) and to evaluate the hemi mandibular volumes from the crossbite (CB) and non-CB sides of the same patients. METHODS: Thirty-eight cone beam computed tomography (CBCT) images were consecutively recruited and the Digital Imaging and Communications in Medicine (DICOM)-formatted scans were volume rendered into a surface three-dimensional (3D) mesh model and volumes to obtain the 3D model of the mandibular bone. To achieve the surface point-to-point analysis of the mandibular models, a reverse engineering software was used. The same procedure was performed for an age-matched control group (19 CBCT images). RESULTS: Total mandibular volume showed a difference of 2.46 cm3 between patients and controls, which was not statistically significant. A mean difference of 1.53 cm3 was found comparing the hemi mandibular volumes from the CB and non-CB sides of PUXB patients, this difference was statistically significant (P ≤ 0.01). Findings for the surface-to-surface deviation analysis, demonstrated a higher percentage of mismatch in patients PUXB, over 10% at 0.5 mm tolerance level. LIMITATIONS: Limitations are related to the intrinsic surfaces matching methodology, that make difficult to evaluate discrepancies among different mandibular anatomical units. CONCLUSION: Adult patients affected by PUXB show a greater mandibular structural asymmetry compared to controls because of a lower matching percentage obtained from the surface-to-surface matching technique. IMPLICATIONS: Treatment of adult patients affected by PUXB should take into consideration the possibility of a mild mandibular asymmetry mainly localized at the condyle and gonial angle levels.