3D-Printed Ultra-Robust Surface-Doped Porous Silicone Sensors for Wearable Biomonitoring.

Three-dimensional flexible porous conductors have significantly advanced wearable sensors and stretchable devices because of their specific high surface area. Dip coating of porous polymers with graphene is a facile, low cost, and scalable approach to integrate conductive layers with the flexible polymer substrate platforms; however, the products often suffer from nanoparticle delamination and overtime decay. Here, a fabrication scheme based on accessible methods and safe materials is introduced to surface-dope porous silicone sensors with graphene nanoplatelets. The sensors are internally shaped with ordered, interconnected, and tortuous internal geometries (i.e., triply periodic minimal surfaces) using fused deposition modeling (FDM) 3D-printed sacrificial molds. The molds were dip coated to transfer-embed graphene onto the silicone rubber (SR) surface. The presented procedure exhibited a stable coating on the porous silicone samples with long-term electrical resistance durability over ∼12 months period and high resistance against harsh conditions (exposure to organic solvents). Besides, the sensors retained conductivity upon severe compressive deformations (over 75% compressive strain) with high strain-recoverability and behaved robustly in response to cyclic deformations (over 400 cycles), temperature, and humidity. The sensors exhibited a gauge factor as high as 10 within the compressive strain range of 2-10%. Given the tunable sensitivity, the engineered biocompatible and flexible devices captured movements as rigorous as walking and running to the small deformations resulted by human pulse.