The Influence of the Gonial Angle on the Initial Biomechanical Stability of the Plate Osteosynthesis in Polyurethane Mandibles With Angle Fractures.

The aim of the present study was to examine the biomechanical stability of the mandibular angle fractures (MAF) fixated with standard titanium miniplates in polyurethane models with different gonial angles (GA). Three custom molds were prepared for 3-dimensional printed mandibles with low, normal and high GA. Twenty polyurethane replicas were cast per group and standard MAFs were created on each sample. Fractures were stabilized with 1 4-hole standard titanium miniplate inserted over the superior alveolar border. Half of the samples were subjected to molar loading and the other half to the incisal loading up until 150 N force magnitude. The load-displacement curves and the horizontal moment arms were recorded and analyzed. The samples with high GA demonstrated greater displacement than those with normal and low GA during molar loading (P < 0.05 for both). After correcting for the effects of the moment arm, the incisal loading also resulted in higher mean displacement in the high GA group than the others (P < 0.05 for both) and the normal GA samples showed higher displacement after 100 N level compared to those in low GA (P < 0.05). Within the limits of this in vitro study, it can be concluded that the MAFs of the polyurethane mandibles with high GA fixated with 1 standard monocortical plate are more likely to demonstrate higher displacement values under the effects of the molar and incisal loadings than do the mandibles with normal and low GA.