Converting waste lignin into nano-biochar as a renewable substitute of carbon black for reinforcing styrene-butadiene rubber.

Industrial waste lignin was commonly burnt or discharged into river in the past. However, in this study, lignin has been converted into high value-added nano-biochar as a renewable reinforcing filler of styrene-butadiene rubber (SBR) by a simple high-temperature carbonization treatment. Herein, the physicochemical change in lignin before and after carbonization was investigated. It was found that lignin-derived biochar (LB) consisted of vesicle-like primary nanoparticles which were closely packed to form "high-structure" irregular fragments with a high specific surface area (83.41 m2/g). When incorporating LB into SBR, the tensile properties of LB/SBR composites were significantly improved. At the filler loading of 40 phr, the tensile strength and elongation at break of the rubber composite were improved up to 7.1-folds and 2.4-folds of pristine SBR, respectively. Compared to commercial carbon black (CB) N330, the LB showed a similar reinforcing effect on SBR. However, the analysis on the morphology, stress-strain behavior and dynamic mechanical behavior suggested distinct reinforcing mechanisms for LB- and CB-filled rubber composites, due to the difference in the surface properties and structural characteristic of fillers. This work showed the application potential of LB as a renewable substitute of CB in rubber industry and brought environmental and economic benefits for the disposal of lignin.