OBJECTIVE: The aim of this study was to observe the resin/dentin interfaces of universal adhesives by using scanning electron microscopy (SEM), and to compare their morphologies with conventional etch & rinse (ER) and self-etch (SE) adhesive systems. METHODS: Two three-step and one two-step ER adhesives and two two-step and two single-step SE adhesives were used for comparison with seven universal adhesives in ER mode and SE mode, respectively. Bonded surfaces with bovine teeth were longitudinally sectioned and mirror-polished. Half of the samples were treated with HCl and NaOCl solutions. The interfaces were subjected to argon ion beam etching and then observed by scanning electron microscopy. RESULTS: The thickness of the adhesive layer (AL) of most of the seven universal adhesives and single-step SE adhesives was similar. Universal adhesives in SE mode formed a hybrid smear layer as a high-density zone between the AL and dentin. The thickness of the hybrid layer (HL) of the universal adhesives in ER mode was ∼1-2μm, with a high-density zone (reaction layer [RL]) below the HL. CONCLUSION: The morphological features of most universal adhesives in SE mode and single-step SE adhesives are similar. Although resin-dentin interfaces of universal adhesives in ER mode resemble those of ER adhesives, universal adhesives have a distinctive feature, an RL. SIGNIFICANCE: The RL might be a sign of chemical bonding even when using universal adhesives in ER mode.
OBJECTIVE: The aim of this study was to observe the resin/dentin interfaces of universal adhesives by using scanning electron microscopy (SEM), and to compare their morphologies with conventional etch & rinse (ER) and self-etch (SE) adhesive systems. METHODS: Two three-step and one two-step ER adhesives and two two-step and two single-step SE adhesives were used for comparison with seven universal adhesives in ER mode and SE mode, respectively. Bonded surfaces with bovine teeth were longitudinally sectioned and mirror-polished. Half of the samples were treated with HCl and NaOCl solutions. The interfaces were subjected to argon ion beam etching and then observed by scanning electron microscopy. RESULTS: The thickness of the adhesive layer (AL) of most of the seven universal adhesives and single-step SE adhesives was similar. Universal adhesives in SE mode formed a hybrid smear layer as a high-density zone between the AL and dentin. The thickness of the hybrid layer (HL) of the universal adhesives in ER mode was ∼1-2μm, with a high-density zone (reaction layer [RL]) below the HL. CONCLUSION: The morphological features of most universal adhesives in SE mode and single-step SE adhesives are similar. Although resin-dentin interfaces of universal adhesives in ER mode resemble those of ER adhesives, universal adhesives have a distinctive feature, an RL. SIGNIFICANCE: The RL might be a sign of chemical bonding even when using universal adhesives in ER mode.
Authors: Louis Hardan; Giovana Orsini; Rim Bourgi; Carlos Enrique Cuevas-Suárez; Marco Nicastro; Florin Lazarescu; Dimitar Filtchev; Elizabeth Cornejo-Ríos; Juan Eliezer Zamarripa-Calderón; Krzysztof Sokolowski; Monika Lukomska-Szymanska Journal: Polymers (Basel) Date: 2022-03-11 Impact factor: 4.329