Hannah Rice1,2, Gillian Weir2, Matthieu B Trudeau3, Stacey Meardon4, Timothy Derrick5, Joseph Hamill2. 1. Sport and Health Sciences, University of Exeter, Exeter, UNITED KINGDOM. 2. Biomechanics Laboratory, University of Massachusetts, Amherst, MA. 3. Human Performance Laboratory, Brooks Running Company, Seattle, WA. 4. Department of Physical Therapy, East Carolina University, NC. 5. Department of Kinesiology, Iowa State University, IA.
Abstract
INTRODUCTION: Stress fractures of the tibia are a problematic injury among runners of all levels. Quantifying tibial stress using a modeling approach provides an alternative to invasive assessments that may be used to detect changes in tibial stress during running. This study aimed to assess the repeatability of a tibial stress model and to use this model to quantify changes in tibial stress that occur throughout the course of a 40-min prolonged treadmill run. METHODS: Synchronized force and kinematic data were collected during prolonged treadmill running from 14 recreational male rearfoot runners on two separate occasions. During each session, participants ran at their preferred speed for two consecutive 20-min runs, separated by a 2-min pause. The tibia was modeled as a hollow ellipse and bending moments and stresses at the distal third of the tibia were estimated using beam theory combined with inverse dynamics and musculoskeletal modeling. RESULTS: Intraclass correlation coefficients indicated good-to-excellent repeatability for peak stress values between sessions. Peak anterior and posterior stresses increased after 20 min of prolonged treadmill running and were 15% and 12% greater, respectively, after 40 min of running compared with the start of the run. CONCLUSION: The hollow elliptical tibial model presented is a repeatable tool that can be utilized to assess within-participant changes in peak tibial stress during running. The increased stresses observed during a prolonged treadmill run may have implications for the development of tibial stress fracture.
INTRODUCTION:Stress fractures of the tibia are a problematic injury among runners of all levels. Quantifying tibial stress using a modeling approach provides an alternative to invasive assessments that may be used to detect changes in tibial stress during running. This study aimed to assess the repeatability of a tibial stress model and to use this model to quantify changes in tibial stress that occur throughout the course of a 40-min prolonged treadmill run. METHODS: Synchronized force and kinematic data were collected during prolonged treadmill running from 14 recreational male rearfoot runners on two separate occasions. During each session, participants ran at their preferred speed for two consecutive 20-min runs, separated by a 2-min pause. The tibia was modeled as a hollow ellipse and bending moments and stresses at the distal third of the tibia were estimated using beam theory combined with inverse dynamics and musculoskeletal modeling. RESULTS: Intraclass correlation coefficients indicated good-to-excellent repeatability for peak stress values between sessions. Peak anterior and posterior stresses increased after 20 min of prolonged treadmill running and were 15% and 12% greater, respectively, after 40 min of running compared with the start of the run. CONCLUSION: The hollow elliptical tibial model presented is a repeatable tool that can be utilized to assess within-participant changes in peak tibial stress during running. The increased stresses observed during a prolonged treadmill run may have implications for the development of tibial stress fracture.