P Hoogervorst1, B Bolsterlee2, M Pijper3, A Aalsma3, N Verdonschot4. 1. Department of Orthopedics, Radboud University Medical Center, Nijmegen, the Netherlands. Electronic address: paul.hoogervorst@radboudumc.nl. 2. Neuroscience Research Australia (NeuRA), Sydney, New South Wales, Australia; Graduate School of Biomedical Engineering, University of New South Wales, Sydney, New South Wales, Australia. 3. BAAT Medical BV, Hengelo, the Netherlands. 4. Department of Orthopedics, Radboud University Medical Center, Nijmegen, the Netherlands; Department of Biomechanical Engineering, University of Twente, Enschede, the Netherlands.
Abstract
BACKGROUND: The forces acting on the human clavicle in vivo are difficult if not impossible to measure. The goal of this study is to quantify the forces acting on the human clavicle during shoulder abduction, forward humeral elevation and three activities of daily living using the Delft Shoulder and Elbow Model. METHODS: The Delft Shoulder and Elbow Model and a computed tomography scan of a clavicle were used to calculate the forces and moments acting on the entire clavicle and on three planes within the middle third of the clavicle during the simulated movements. FINDINGS: The largest resultant force simulated across the clavicle was 126 N during abduction. Maximum resultant moments of 2.4 Nm were identified during both abduction and forward humeral elevation. The highest forces in the middle third of the clavicle were of a compressive nature along the longitudinal axis of the clavicle, increasing to 97 N during forward humeral elevation and 91 N during abduction. Forces in opposite direction along the y-axis were identified on either side of the conoid ligament. The three simulated activities of daily living had similar ranges of forces and moments irrespective of the sagittal plane in which these activities were performed. INTERPRETATION: Peak forces occurred at different locations on the middle third of the clavicle during different movements. The results create an understanding of the forces and their distribution across the clavicle during activities of daily living. These data may be helpful in the development of clavicular fixation devices. LEVEL OF EVIDENCE: Biomechanical study.
BACKGROUND: The forces acting on the human clavicle in vivo are difficult if not impossible to measure. The goal of this study is to quantify the forces acting on the human clavicle during shoulder abduction, forward humeral elevation and three activities of daily living using the Delft Shoulder and Elbow Model. METHODS: The Delft Shoulder and Elbow Model and a computed tomography scan of a clavicle were used to calculate the forces and moments acting on the entire clavicle and on three planes within the middle third of the clavicle during the simulated movements. FINDINGS: The largest resultant force simulated across the clavicle was 126 N during abduction. Maximum resultant moments of 2.4 Nm were identified during both abduction and forward humeral elevation. The highest forces in the middle third of the clavicle were of a compressive nature along the longitudinal axis of the clavicle, increasing to 97 N during forward humeral elevation and 91 N during abduction. Forces in opposite direction along the y-axis were identified on either side of the conoid ligament. The three simulated activities of daily living had similar ranges of forces and moments irrespective of the sagittal plane in which these activities were performed. INTERPRETATION: Peak forces occurred at different locations on the middle third of the clavicle during different movements. The results create an understanding of the forces and their distribution across the clavicle during activities of daily living. These data may be helpful in the development of clavicular fixation devices. LEVEL OF EVIDENCE: Biomechanical study.
Authors: Maria Prado-Novoa; Laura Perez-Sanchez; Belen Estebanez; Salvador Moreno-Vegas; Ana Perez-Blanca Journal: Materials (Basel) Date: 2022-03-31 Impact factor: 3.623