Literature DB >> 29754303

Preparation and Cr(VI) removal performance of corncob activated carbon.

Hongyan Li1,2, Pei Gao3,4, Jianguo Cui3,4, Feng Zhang3,4, Fang Wang5, Jici Cheng3.   

Abstract

Corncob activated carbon (CCAC) was prepared by a H3PO4 activation method. The optimum conditions for the preparation of CCAC were determined by orthogonal experiments. The effects of pH, reaction time, CCAC dosage, and hexavalent chromium (Cr(VI)) concentrations on Cr(VI) removal by CCAC were studied. Corn straw activated carbon (CSAC) was also prepared using the optimum preparation conditions determined for CCAC. The properties of samples were characterized by Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), Brunauer-Emmett-Teller (BET) analysis, scanning electron microscopy (SEM), and energy dispersive spectroscopy (EDS). The results showed that the optimum preparation conditions for CCAC were as follows: a mass of corncob of 10 g; a mass ratio of corncob to H3PO4 of 1:2; a 5% H3BO3 content of 10 mL; an impregnation time of 45 min; a carbonization temperature of 500 °C. The optimum conditions for the removal of Cr(VI) were as follows: pH < 9; temperature, 308 K; rotation speed, 150 r min-1; reaction time, 60 min; CCAC dosage, 1 g L-1. The Cr(VI) removal rate was above 98%, and the maximum adsorption capacity of CCAC was 9.985 mg g-1. The concentration of residual Cr(VI) in water was less than 0.05 mg L-1. FTIR showed that the surfaces of the samples had more oxygen-containing functional groups, which promoted the adsorption. XRD showed that CCAC and CSAC had similar peaks and that these peaks promoted the adsorption of Cr(VI). BET indicated that the number of pores in the samples followed the order CCAC > CSAC > CAC. SEM showed that the CCAC surface had a more porous structure, which enhanced adsorption. EDS showed that the C contents of CCAC and CSAC were much higher than that of CAC. Cr(VI) adsorption on CCAC followed quasi-second-order kinetics and was in accordance with a Langmuir adsorption isotherm, with monolayer adsorption. The adsorption reaction was endothermic, where higher temperatures increased the degree of spontaneous reaction.

Entities:  

Keywords:  Corncob activated carbon; Cr(VI); Dynamics; H3PO4 activation method; Thermodynamics

Mesh:

Substances:

Year:  2018        PMID: 29754303     DOI: 10.1007/s11356-018-2026-y

Source DB:  PubMed          Journal:  Environ Sci Pollut Res Int        ISSN: 0944-1344            Impact factor:   4.223


  4 in total

1.  Adsorption and removal of chromium (VI) contained in aqueous solutions using a chitosan-based hydrogel.

Authors:  Pâmela Becalli Vilela; Amanda Dalalibera; Eduardo Costa Duminelli; Valter Antonio Becegato; Alexandre Tadeu Paulino
Journal:  Environ Sci Pollut Res Int       Date:  2018-09-18       Impact factor: 4.223

2.  Application of ZnO nanorods doped with Cu for enhanced sonocatalytic removal of Cr(VI) from aqueous solutions.

Authors:  Kazem Godini; Mahsa Tahergorabi; Mohammad Naimi-Joubani; Mehdi Shirzad-Siboni; Jae-Kyu Yang
Journal:  Environ Sci Pollut Res Int       Date:  2019-12-13       Impact factor: 4.223

3.  Porous Activated Carbon from Lignocellulosic Agricultural Waste for the Removal of Acetampirid Pesticide from Aqueous Solutions.

Authors:  Somaia G Mohammad; Sahar M Ahmed; Abd El-Galil E Amr; Ayman H Kamel
Journal:  Molecules       Date:  2020-05-17       Impact factor: 4.411

4.  High-efficiency adsorption and regeneration of methylene blue and aniline onto activated carbon from waste edible fungus residue and its possible mechanism.

Authors:  Hongyan Li; Lianxin Liu; Jianguo Cui; Jiali Cui; Fang Wang; Feng Zhang
Journal:  RSC Adv       Date:  2020-04-08       Impact factor: 4.036

  4 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.