Literature DB >> 29505889

Recovery of low volumes of wear debris from rat stifle joint tissues using a novel particle isolation method.

J Patel1, S Lal2, K Nuss3, S P Wilshaw4, B von Rechenberg3, R M Hall5, J L Tipper6.   

Abstract

Less than optimal particle isolation techniques have impeded analysis of orthopaedic wear debris in vivo. The purpose of this research was to develop and test an improved method for particle isolation from tissue. A volume of 0.018 mm3 of clinically relevant CoCrMo, Ti-6Al-4V or Si3N4 particles was injected into rat stifle joints for seven days of in vivo exposure. Following sacrifice, particles were located within tissues using histology. The particles were recovered by enzymatic digestion of periarticular tissue with papain and proteinase K, followed by ultracentrifugation using a sodium polytungstate density gradient. Particles were recovered from all samples, observed using SEM and the particle composition was verified using EDX, which demonstrated that all isolated particles were free from contamination. Particle size, aspect ratio and circularity were measured using image analysis software. There were no significant changes to the measured parameters of CoCrMo or Si3N4 particles before and after the recovery process (KS tests, p > 0.05). Titanium particles were too few before and after isolation to analyse statistically, though size and morphologies were similar. Overall the method demonstrated a significant improvement to current particle isolation methods from tissue in terms of sensitivity and efficacy at removal of protein, and has the potential to be used for the isolation of ultra-low wearing total joint replacement materials from periprosthetic tissues. STATEMENT OF SIGNIFICANCE: This research presents a novel method for the isolation of wear particles from tissue. Methodology outlined in this work would be a valuable resource for future researchers wishing to isolate particles from tissues, either as part of preclinical testing, or from explants from patients for diagnostic purposes. It is increasingly recognised that analysis of wear particles is critical to evaluating the safety of an orthopaedic device.
Copyright © 2018 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.

Entities:  

Keywords:  Cobalt chromium; Particle isolation; Silicon nitride; Titanium; Total joint replacement; Wear

Mesh:

Substances:

Year:  2018        PMID: 29505889     DOI: 10.1016/j.actbio.2018.02.030

Source DB:  PubMed          Journal:  Acta Biomater        ISSN: 1742-7061            Impact factor:   8.947


  5 in total

1.  Development and optimisation data of a tissue digestion method for the isolation of orthopaedic wear particles.

Authors:  J Patel; S Lal; S P Wilshaw; R M Hall; J L Tipper
Journal:  Data Brief       Date:  2018-07-31

2.  Analytical Problems with Preparation of Paraspinal Tissues from Patients with Spinal Fusion for Analysis of Titanium.

Authors:  Jan Sawicki; Anna Danielewicz; Magdalena Wójciak; Michał Latalski; Agnieszka Skalska-Kamińska; Katarzyna Tyszczuk-Rotko; Ireneusz Sowa
Journal:  Molecules       Date:  2021-04-07       Impact factor: 4.411

3.  Mixed material wear particle isolation from periprosthetic tissue surrounding total joint replacements.

Authors:  Ashley A Stratton-Powell; Sophie Williams; Joanne L Tipper; Anthony C Redmond; Claire L Brockett
Journal:  J Biomed Mater Res B Appl Biomater       Date:  2022-05-09       Impact factor: 3.405

4.  Validation of a novel particle isolation procedure using particle doped tissue samples.

Authors:  J Patel; S Lal; S P Wilshaw; R M Hall; J L Tipper
Journal:  Data Brief       Date:  2018-05-01

5.  Recovery rate data for silicon nitride nanoparticle isolation using sodium polytungstate density gradients.

Authors:  J Patel; S Lal; S P Wilshaw; R M Hall; J L Tipper
Journal:  Data Brief       Date:  2018-06-19
  5 in total

北京卡尤迪生物科技股份有限公司 © 2022-2023.